Farenheit Technologies MD-1210CMX User Manual

12.1 TFT-LCD DVD/SD/USB COMBO MONITOR
M
MENU
AV
PLAY
POWER
OWNER S MANUAL
Contents
Caution
Features and Controls Monitor/DVD Player Remote Control
Power and Mode Selection Releasing The Monitor Turning on The Monitor Mute Function
AV mode
Picture Control Contrast/Brightness/Color/FM
DVD Setup Setup Menu General Setup TV Aspect Ratio
Angle Viewing OSD Language Screen Saver
Audio Setup Dolby Digital Setup Equalizer Settings Video Setup Quality Preferences Setup TV Type
PBC Audio Subtitle Disc Menu Parental Default Password Setup
Password Mode Password Change DVD Functions
Eject Vol+/Vol-
Mute
4
Play or Pause
6
Audio
6
Stop
8
Arrows
10
Setup
10
Menu
10
Display
10
Number Buttons Subtitle
11
Title
12
Slow
12
Fast Reverse Searching
13
Fast Forward Searching
13
Previous
14
Next
14
Repeat A-B
14
Repeat
14
NTSC/PAL
15
Angle
15
PBC
16
Zoom
16
GO TO
18
SD/USB Functions
18 21
Connection Diagram
21 21
Installation
21 21
Disc Information
22
Troubleshooting
22 22
Specifications
23 23
23 24 24 24
24 24
24 25
25 25
25 26
26 27 27 27 28 28 29 29
29 30 30
30 31 31 31
32
33
34
35
36
37
3
Caution
Please read and observe all warnings and instructions in this manual and those marked on the unit. Retain this booklet for future reference.
There are two kinds of alarm symbols as follows:
The lightning bolt with arrowhead inside in an equilateral
WARNING
CAUTION
P
O W
E R
A
V
MEN
U
triangle is intended to alert the user to the presence of
dangerous voltage within the product s enclosure that may be
""
of sufficient magnitude to constitute a risk of electric shock to people.
The exclamation point inside an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
WARNING
Installation of all TV monitors must be out of the driver s field of vision.
,
,
Do not mount the product where it will obstruct the deployment of the airbag or in an area where it would affect the driver s ability to control the vehicle. Also be careful to avoid mounting the product where it can become hazardous during sudden stops or in the event of an accident.
SPECIFICATIONS
Power
Screen Format
Resolution Pixel
Color System
A/V Input
A/V Output
Dimension
Dimension
Note: This equipment has been tested and has been found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference. In some cases, the user will be required to correct the interference at his own expense.
DC 12V
4:3
2400x600
NTSC/PALAuto Select
DVD-AV1-AV2
1EA
With shroud:15.1(L)X13.9(W)X3.5(H)inches
Without shroud:14.8(L)X13.6(W)X2.5(H)inches
Do not try and service these products yourself, a qualified service center or factory service center for all repairs.
Be careful not to drop or apply under pressure to the front panel of your video monitor. If the screen cracks due to misuse, your warranty will be void!
locale
Use extra caution with any liquids in your car. If you or your child spills any liquid on these products, pull your vehicle to the roadside
or wipe the products with a towel. Do not operate the equipment until all liquids have either evaporated or you have had the monitor inspected at a service center by a qualified technician. Severe harm or danger can result.
and turn the key off to disconnect
Use only a damp cloth to clean the screen and use only purified water on the cloth. wring out all excess water prior to wiping the screen. Do not use any cleaners or chemicals to clean the screen. In most cases a dry cloth will do!
4
37
Troubleshooting
Caution
CAUTION
Symptom
Buttons do not work.
No sound
Remote control does not work properly.
Items to Check
Is the power turned on?
Is the audio which is connected with the audio cable set to receive the DVD signal output?
Is audio cable connected securely? Is the monitor which is connected
with the audio cable turned on?
Is the audio output set in the correct position?
Is the remote control facing the remote sensor?
Is the distance too far?
Is there any obstacle in the middle?
Is the battery weak?
Actions to be Taken
Check the car battery capacity.
Select the correct input mode for the audio receiver. Connect the audio cable into the jacks securely. Turn on the monitor connected with the audio cable. Set the Audio Output to the correct position,
and then turn on the DVD player again by pressing the POWERbutton.
Point the remote control toward the remote sensor of the product.
Use the remote control within 15 feet. Remove the obstacle. Replace with new battery.
Moisture or condensation on lens
When a disc is brought from a cold environment to a warm one, there may be moisture on the the disc, or condensation on the pickup lens. It will affect disc playback.
1. Remove the disc from the DVD player.
2. Turn on the power and leave it on for an hour to vaporize the condensation.
Quality installations are best performed by qualified and certified installers.
Don t touch the unit if there is a flash of lightning. You may receive an electric shock.
Do not cover or stop up heater ducts or vents. It may cause a fire or receive an electric shock.
Watching the monitor for an extended period of time without the engine running may deplete the vehicle s battery charge.
This product is designed for operation with a 12 Volt DC, negative ground vehicle. It is not suitable for operation under other conditions or voltages.
Do not bring magnetic devices such as credit card or magnetic card near the magnets.
Operating Notes
1. The operating temperature of this product is limited to 14 ~+140 F.
2. If your vehicle is extremely hot or cold you must allow time for your air conditioner or heater to cool or heat the vehicle until operating temperatures have returned to normal operating ranges.
3. Optimal picture quality is achieved when viewed from directly front of the monitor (+/-30degrees).
4. Do not open the housing and attempt to make any repairs yourself. Refer servicing to qualified personnel.
5. DVD Players use an invisible laser beam which can cause hazardous radiation exposure. Be sure to operate the unit correctly as instructed.
6. Do not cut the car power supply off while a disc is playing. It can cause damage to the DVD Player.
7. If the buttons get stuck, please try to press the up of buttons, it will get back. It won't impact using normal.
8. If you cann't find the files name in list when playing, please reset units or turn off/on over again.
9. If the unit cann't be change mode when playing some special files which the unit didn't support, please reset units or turn off/on over again.
36
5
Features and Controls
Disc Information
Monitor/DVD Player
Vol-
PLAY
Vol+
MONITOR
Remote Control
M
MENU
AV
DVD features
DVD discs provide high-resolution images with high-quality sound. This DVD player can play not only DVD discs of various versions, but also S-VCD, VCD, audio CD and MP3 discs.
Discs that cannot be played
DVD-RW, DVD-REM, CD-ROM, CD-EXTRA discs cannot be played on this unit. In addition, a CD or a CD-RW which was recorded on special software cannot be played.
Region code
Your DVD player is designed and manufactured to region management information that is recorded on a DVD disc. Please check the region code. 1: North America 2: Japan 3: Korea and Southeast Asia 4: Australia, Mid & South America 5: Russia 6: China
How to handle the disc
POWER
Monitor/DVD Player
Don t touch the shiny side of the disc (the side with the embedded information).
Don t stick a label or a glue-based note on either side of the disc.
Don t use discs that have glue or a damaged label with exposed adhesive residue. It might result in damage to your DVD player.
Don t put discs in the sunshine. Park your car in the shade.
How to handle the discs
Only use round discs. Discs with other shapes like a star, a heart, etc. may cause damage to the player. If a disc is dirty, wipe softly with a wet cloth and then with a dry one. Before playback, wipe the disc outward from the center with a clean cloth. Do not use any type of solvent such as thinner, benzene, commercially available cleaners or antistatic spray. To avoid damaging your DVD player, don t use a scratched disc.
Wireless Headphones (Not Included)
6
35
Loading...
+ 14 hidden pages