Farenheit Technologies MD-1210CM User Manual

MD-1210CM

12.1 TFT-LCD DVD/SD/USB/ iPOD COMBO MONITOR

PLAY

POWER

OWNER S MANUAL

Contents

Caution

Features and Controls Monitor/DVD Player Remote Control

Power and Mode Selection Releasing The Monitor Turning on The Monitor Mute Function

Selecting an AV mode

Picture Control Contrast/Brightness/Color/FM

DVD Setup Setup Menu General Setup TV Aspect Ratio

Angle Viewing OSD Language Captions Screen Saver

Last Position memory

Audio Setup Speaker Setup Equalizer Settings Preferences Setup TV Type

Parental Audio Subtitle

Default Password Setup Password Mode Password Change

DVD Functions Eject

Vol+/Vol-

Mute

Play or Pause

Audio

Stop

Arrows

Setup

Display

Number Buttons Subtitle

Title

Slow

Fast Reverse Searching

Fast Forward Searching

Repeat A-B

Repeat

NTSC/PAL

Angle

15 15

PBC Zoom

GO to

15 16

SD/USB/iPOD Functions

Connection Diagram

17 17

Installation 17 18

Disc Information 18

Troubleshooting 19

Specifications

19 19

20 20

20 21

21 21

21 22

22 23 23 23 24 24 25 25

25 26 26

26 27 27 27

Caution

Please read and observe all warnings and instructions in this manual and those marked on the unit. Retain this booklet for future reference.

There are two kinds of alarm symbols as follows:

The lightning bolt with arrowhead inside in an equilateral

WARNING

CAUTION

O W

E R

MEN

triangle is intended to alert the user to the presence of

dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to people.

The exclamation point inside an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.

WARNING

Installation of all TV monitors must be out of the driver s field of vision.

Do not mount the product where it will obstruct the deployment of the airbag or in an area where it would affect the driver s ability to control the vehicle. Also be careful to avoid mounting the product where it can become hazardous during sudden stops or in the event of an accident.

SPECIFICATIONS

Power

Screen Format

Resolution Pixel

Color System

A/V Input

A/V Output

Dimension

Note: This equipment has been tested and has been found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference. In some cases, the user will be required to correct the interference at his own expense.

DC 12V

4:3

2400x600

NTSC/PALAuto Select

DVD-iPOD-AV1-AV2

1EA

With shroud:15.1(L)X13.9(W)X3.5(H)inches

Without shroud:14.8(L)X13.6(W)X2.5(H)inches

Do not try and service these products yourself, a qualified service center or factory service center for all repairs.

Be careful not to drop or apply under pressure to the front panel of your video monitor. If the screen cracks due to misuse, your warranty will be void!

Be careful not to overload your cigarette lighter plug by adding more than one device at a time.

locale

Use extra caution with any liquids in your car. If you or your child spills any liquid on these products, pull your vehicle to the roadside

or wipe the products with a towel. Do not operate the equipment until all liquids have either evaporated or you have had the monitor inspected at a service center by a qualified technician. Severe harm or danger can result.

and turn the key off to disconnect

Use only a damp cloth to clean the screen and use only purified water on the cloth. wring out all excess water prior to wiping the screen. Do not use any cleaners or chemicals to clean the screen. In most cases a dry cloth will do!

Troubleshooting

Caution

CAUTION

Symptom

Buttons donot work.

No sound

Remote controldoes not workproperly.

Items to Check

Is thepower turned on?

Is theaudio which is connected with the audiocable set to receive the DVDsignal output?

Is audiocable is connected securely? Is themonitor which is connected

with the audio cable turned on?

Is thedigital audio output set in thecorrect position?

Is theremote control facing the remotesensor?

Is thedistance too far?

Is thereany obstacle in the middle?

Is thebattery weak?

Actions to be Taken

Check the car battery capacity.

Select the correct input mode for the audio receiver. Connect the audio cable into the jacks securely. Turn on the monitor connected with the audio cable. Set the DigitalAudio Output to the correct position,

and thenturn on the DVD player again by pressing the POWERbutton.

Point theremote control toward the remote sensor of the product.

Use the remote control within 15 feet. Remove the obstacle. Replace withnew battery.

Moisture or condensation on lens

When a disc is brought from a cold environment to a warm one, there may be moisture on the the disc, or condensation on the pickup lens. It will affect disc playback.

1. Remove the disc from the DVD player.

2. Turn on the power and leave it on for an hour to vaporize the condensation.

Quality installations are best performed by qualified and certified installers.

Don t touch the unit if there is a flash of lightning. You may receive an electric shock.

Do not cover or stop up heater ducts or vents. It may cause a fire or receive an electric shock.

Watching the monitor for an extended period of time without the engine running may deplete the vehicle s battery charge.

This product is designed for operation with a 12 Volt DC, negative ground vehicle. It is not suitable for operation under other conditions or voltages.

Do not bring magnetic devices such as credit card or magnetic card near the magnets.

Operating Notes

1. The operating temperature of this product is limited to 14 ~+140 F.

2. If your vehicle is extremely hot or cold you must allow time for your air conditioner or heater to cool or heat the vehicle until operating temperatures have returned to normal operating ranges.

3. Optimal picture quality is achieved when viewed from directly front of the monitor (+/-30degrees).

4. Do not open the housing and yourself. Refer

attempt to make any repairs

servicing to qualified personnel.

5. DVD Players use an invisible laser beam which can cause hazardous radiation exposure. Be sure to operate the unit correctly as instructed.

6. Do not cut the car power supply off while a disc is playing. It can cause damage to the DVD Player.

Monitor / Player System Components

iPOD

MONITOR

Remote Control

PLAY

POWER

Disc Information

DVD features

DVD discs provide high-resolution images with high-quality sound and surround sound effects. This DVD player can play not only DVD discs of various versions, but also S-VCD, VCD, audio CD and MP3 discs.

Discs that cannot be played

DVD-RW, DVD-REM, CD-ROM, CD-EXTRA discs cannot be played on this unit. In addition, a CD or a CD-RW which was recorded on special software cannot be played.

Region code

Your DVD player is designed and manufactured to region management information that is recorded on a DVD disc. Please check the region code. 1: North America 2: Japan 3: Korea and Southeast Asia 4: Australia, Mid & South America 5: Russia 6: China

How to handle the disc

Don t touch the shiny side of the disc (the side with the embedded information). Don t stick a label or a glue-based note on either side of the disc. Don t use discs that have glue or a damaged label with exposed adhesive reside. It might result in damage to your DVD player. Don t put discs in the sunshine. Park your car in the shade.

WARNING:

iPOD

only can work between 0Cto35C(32Fto95F) please do not leave in the flip down unit when the car is left unattended. The high temperature of the locked car on a hot day will damage your .

iPOD

Monitor/DVD Player

Wireless Headphones

How to handle the discs

Only use round discs. Discs with other shapes like a star, a heat, etc. may cause damage to the player.If a disc is dirty, wipe softly with a wet cloth and then with a dry one. Before playback, wipe the disc outward from the center with a clean cloth. Do not use any type of solvent such as thinner, benzene, commercially available cleaners or antistatic spray. To avoid damaging your DVD player, don t use a scratched disc.

+ 12 hidden pages