Fantech RIL-150SW, RIL-200SW, RIL-150T, RIL-200T Installation & Maintenance Instructions Manual

Installation (cont)...

2.5. Mount the base in the desired position using the fasteners supplied.

2.6. Replace the fan body in-between the spigots and tighten the two
retaining clamps or clamp screws.

Fan Maintenance

3.1. Inspect the fan at least once every 12 months to ensure that the motor
and fan blades are clean. Any build up of dust should be removed using
a non-abrasive cleaner.

3.2. All fastenings should be checked for tightness.

3.3. Bearings are of the ‘sealed for life’ type and will not need a detailed
inspection.

Wiring Diagram

In-Line

Duct Mounted Fan

RIL-150SW

Contact Us

RIL-200SW

INSTALLATION & MAINTENANCE

INSTRUCTIONS

Part No: INST-RIL-SW 11/12

Specification

Dimensions

Model

RIL-150SW 112 60 100 80 295 147 200 225 236 2.7

RIL-200SW 124 94 108.5 100 302 198 217 235 265 4.9

Model

RIL-150SW HIGH ( II ) 2500 0.22 50
LOW ( I ) 1950 0.19 44

RIL-200SW HIGH ( II ) 2500 0.50 120
LOW ( I ) 2000 0.45 100

A B C D E F G H J

Electrical

Speed Speed r/min

FLC Amps Input W

Data

To select high or low speed, switch the speed selector fitted to
the side of the unit’s junction box to either “II” for high speed or
“I” for low speed.

Weight

kg

1.5 This product is not intended for use by persons (including children)
with reduced physical sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the product by a person responsible
for their safety. Children should be supervised to ensure that they do
not play with the product.

1.6 Precautions must be taken to avoid back-flow of gases into the room
from the open flue of gas or other fuel burning appliances.

1.7 A minimum of one (1) metre of duct is to be fitted to the fan inlet and
discharge spigots.

1.8 To avoid a hazard, a damaged supply cord must be replaced by the
manufacturer.

Installation

Warning: The fan must be isolated from the power supply during
installation and maintenance.

2.1. Upon receipt, the fan should be inspected for any damage.

2.2. Check the details on the rating plate to ensure that the correct power
supply is available

2.3. Means for electrical disconnection must be incorporated in the wiring
installation in accordance with the relevant wiring regulations.

2.4. Remove the fan body from the spigots that are attached to the base by
releasing the two retaining clamps (RIL-150SW, see diagram), or the
two clamp screws (RIL-200SW).

General

1.1. It is important that these Installation and Maintenance Instructions are
fully adhered to.

1.2. All electrical installations must be carried out by a suitably qualified
and competent personnel in accordance with all statutory requirements.

1.3. The fan is designed for use in an ambient temperature of up to 40°C.
It is not suitable for corrosive or explosive atmospheres.

1.4. The installer should provide easy access to the fan to facilitate future

maintenance, and ensure that the fan is adequately supported.