Fanimation Palmetto FP600 Series Specification Sheet

Copyright 2007 Fanimation, Inc.

2007/12

10983 Bennett Parkway

Zionsville, IN 46077

Toll Free [phone]

FAX [phone]

Outside U.S. call [phone]

Visit Our Website www.fanimation.com

The Palmetto® Ceiling Fan Assembly

INSTALLATION REQUIREMENTS:
It is recommended that each drive shaft support requires backing consisting of 3/4˝ plywood (20˝ x 20˝) attached to the
ceiling joists, snug above the sheet rock, and able to support 100 lbs. Not recommended for sound-sensitive areas.

ELECTRICAL REQUIREMENTS:
The drive shaft support that contains the motor will require a 120 VAC, 60 Hz, 15 amps electrical feed via a fl ush mount
junction box positioned on center and wired back to an on/off switch (motor unit is single speed). Any support that
contains a light fi xture will also require a junction box on center with a circuit wired back to a dimmer circuit or on/off
switch. The lights and motor should be on separate switch legs.

FAN SPEED:
Single-speed, 15 rpm; NOT designed for signifi cant air movement.

BLADE OPTIONS:

Various Palm and Bamboo blades are sold seperately. See Catalog or visit our website, www.fanimation.com for more
blade selections.

LIGHTING OPTIONS:

Optional lighting fi tters and light kits are available, including a single bowl fi xture with a maximum of 180 watts and
a variety of four-light fi xtures with a maximum of 240 watts. Can be only mounted on the cap housing. Installation
instructions provided with each light fi tter and light kit. See Catalog or visit our website, www.fanimation.com for more
lighting options.

DAMP LOCATION:

Fan not rated for Damp Location usage.

SPECIFICATION SHEET

Product Specifi cations subject to change

The Palmetto

®

FP600 Series

The Palmetto

®

Fan Assembly

Motor Assembly Unit*

Chain-Driven, 115 volt, 60–50 Hz,

0.62–0.76 amps, 1/20 hp

220 VAC, 50 Hz export version available

Finishes: available in 3 fi nishes

**Available Finish (codes)

AB Antique Brass

BL Black

Ordering Information (Items Sold Seperately)

Item Catalog No. Description

Fan Assembly

FP601**
FP602**
FP603**
FP604**
FP605**

One Section
Two Sections
Three Sections
Four Sections
Five Sections

Blade Sets
(Includes Blade
Holder, Stem and
Hub)

Up to 3 blade sets can be
used per section.

See Catalog or visit
www.fanimation.com for
more blade information

Dimensional Information

A Overall Length

*

10´– 50´

B Support Spacing

†

119 ˝(center of base

to center of base)

10´ 5½˝(outside of base

to outside of base)

C Ceiling to Shaft 27˝

D Base Width 6˝

E Base Length 18˝

F Blade Sweep 48˝

G Overall Drop 51˝

H Blade Radius 24˝

I Blade Length 18˝

J Base Stem Length 4˝

C

B

A

D

E

F

G

**

Insert Finish Codes

Dimensions shown in feet & inches

*

Available 9´ to 45´ (depending on number of sections)

†

Supports can be spaced from between 48˝ to 119˝.
Outside of base to outside of base, if entire 108˝ shaft is used.
Shaft is cut to length required at installation.

NOTES: Not designed for signifi cant air movement.

Not recommended for sound-sensitive areas
(chain-driven motor).

I

H

J

Blades To Floor

7´ minimum

*NOTE: Not recommended for sound-sensitive areas!