Falcon RW Series Installation Instructions Manual
*030388-000-70*
Insert inner and outer spindles into lock hubs.
RW Series
030388-000-70
Mounting and Rehanding Installation Instructions
SPINDLE
Retrot Lever Trim
STEP ONE:
Remove all existing trim from door,
including cylinder if one is installed.
STEP TWO:
NOTE: Because of various hub sizes, be sure
spindles fit properly. Place the enclosed template
over the spindle. Align with door edge and mark the
four (4) thru-bolt hole locations. This should be done
to both sides of the door. Drill the four (4) holes
halfway through from each side of door.
SCREW
6-32x1¹⁄₄”
5/16”
9/32”
INSIDE
3/8”
TEMPLATE
SPRING
SPINDLE
REPLACEMENT PARTS
5/16”
5/16”
SPRING
Spindle
Spindle
Adapter
Spring
IMPORTANT: It may be necessary to enlarge the
trim hole due to varying door preps. Falcon retrofit
trim requires both sides to be 1¹⁄₈” diameter
minimum to clear trim mechanism.
TRIM HOLE
STEP THREE: Before mounting the trim, be
sure to insert spindle springs into each
lever. With spindle in outer hub, place outer
trim over spindle with posts going into thruholes. Place inside trim over spindle and
install the four (4) mounting screws. Before
screws are tightened, check to see that
both levers are operating properly. If
reinstalling the cylinder, determine if a
blocking ring is required. Tighten set screw
then check cylinder for proper function.
OUTSIDE
P/N 021242–001–30
P/N 030329–000–30
P/N 030319–000–30
P/N 021244–001–60
Tighten the four (4) trim mounting screws.
Customer Service
1-877-671-7011 www.allegion.com/us
© Allegion 2014
030388-000-70 Rev. 10/14-d
Printed in U.S.A.
RH/RHR
R
L
L
R
L
VIEWED FROM OUTSIDE
LH/LHR
L
R
assembly to rotate counter-
clockwise to relieve spring
tension.
R
3. Using caution, allow rose
L
R
R
L
L
R
L
Tighten nut and then back off
slightly until rose assembly
rotates freely under plate.
Bend up one tab of lockwash-
er against nut.
7. Reinstall lockwasher and nut.
R
L
up and in line with "L" on
rose assembly.
6. Reinstall plate with "L" side
L
R
L
R
R
R
L
rose assembly clockwise
slightly, and remove plate and
lockwasher.
R
2. Holding lever securely, rotate
L
rotate rose assembly
counterclockwise slightly
past 90 deg.
5. Holding lever securely,
Note: Inside trim is always opposite the outside trim
Reverse sequence to change from left to right hand
L
R
R
L
Example shown is a right hand being changed to a left hand
R
R
L
L
R
RE-HANDING INSTRUCTIONS FOR FALCON RW SERIES LOCK TRIM
with spring hook on opposite
bend tab of lockwasher back
flat. Remove nut.
1. Holding lever as shown,
2
side of post.
4. Remove spring and reinstall
Loading...