Falcon PHASER2 User Manual

FALCON

WOR LD CLASS SE CUR ITY

FALCON PHASER2

Advanced Keyless Entry System

NATIONWIDE INSTALLATION SERVICE

0800 622 474

HELPLINE: 0906 700 10 20

(All calls charged at 50p/min)

Internet: http://www.falcon-security.com

Email: [e-mail]

1. Features
Remote lock and unlock
Car finder
Total closure
Remote boot release
Code learning (up to 4 remotes)
Flashes hazard lights
Universal Central Locking
Siren/horn output

2. Button Function Table

button door lock door unlock ignition on

button #1 once lock lock lock
button #1 2 sec. car finder car finder
button #2 once unlock unlock unlock
button #3 2 sec. boot release boot release

2.04 Button definition

3. Code Learning

The remotes have programmed to the system when leaving the
factory. If necessary there are 2 methods to program a new
remote to the system as follows:

- Power on the system

- Lights flash twice

- Within 10 sec., press the onboard switch 6 times

- The system enters into the code learning mode and the indicator
lights turn on to confirm

- Within 10 sec., press any button of 1

st

remote

- Lights flash once then stay on again to confirm the 1st remote is
programmed to the system

- Follow the same procedure as above to program the 2

nd

, 3rd and

4

th

remote. You have up to 10 sec. for the learning of each

remote

The system will quit the learning mode as follows and the

indicator lights will turn off to confirm:

*Upon programming 4 remotes to the system
*If doing nothing for 10 sec.

The 2nd method of programming the new remote to the system:

- Unlock the door by remote control

- Within 20 sec. turn the ignition on-off 5 times then back to on

- The system enters into code learning mode and the indicator
lights will turn on to confirm

- Within 10 sec. press any button of 1

st

remote

- Lights will flash once and then stay on again to confirm the 1

st

remote is programmed to the system

- Follow the same procedure as above to program 2

nd

, 3rd and 4th

remote. You have up to 10 sec. for the learning of each remote.

- The system will quit the learning mode as follows and the
indicator lights will be off to confirm:

*

Turn the ignition off during the code learning

*

Upon programming 4 remotes to the system

*

If doing nothing for 10 sec.

4. System Operation & Installation

4.01 Door lock

- Press the lock button once with the ignition off

- Doors lock

- Lights flash once

- The siren/horn chirps once (if connected)

- Then window closure output will be on for 40 sec.

*

If pressing the lock button with ignition on then the window
closure output won’t be activated