Falcon HS3, HS4, HS5 User Instruction

HS3 / HS4 / HS5 SERVERY UNITS

USER INSTRUCTIONS

SECTION 1 - GENERAL DESCRIPTION
SECTION 2 - CONTROLS and OPERATION
SECTION 3 - CLEANING and MAINTENANCE

The appliance has been CE-marked on the basis of compliance with the Low Voltage and
EMC Directives for the voltages stated on the data plate.

IMPORTANT

The appliance must only be installed by a qualified person, in compliance with the regulations

in force at the time.

UK regulations are listed on the front of the installation and Service manual.

Regular servicing by a qualified person is recommended to ensure continued safe and efficient per­formance of the unit.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Upon receipt of this manual, the installer should instruct a responsible person (or persons) as to
correct operation of this unit.

The unit is designed FOR PROFESSIONAL USE ONLY and be operated by qualified persons. It is the
responsibility of the supervisor or equivalent to ensure that the user wears SUITABLE PROTECTIVE
CLOTHING. Attention should also be drawn to the fact that some parts of the unit will, by necessity,
become VERY HOT. This could cause burns if touched accidentally.

WEEE Directive Registration No. WEE/DC0059TT/PRO

At end of unit life, dispose of appliance and any replacement
parts in a safe manner, via a licenced waste handler.
Units are designed to be dismantled easily and recycling of all
material is encouraged whenever practicable.

Falcon Foodservice Equipment

HEAD OFFICE AND WORKS

Wallace View, Hillfoots Road, Stirling. FK9 5PY. Scotland.

SERVICELINE CONTACT

Phone: [phone] Fax: [phone]

T100726 Ref.1

SECTION 1 ­GENERAL DESCRIPTION

SECTION 2 - USING THE SERVERY

The servery should be switched on at least 20 minutes
before hot food is placed in bains-marie or hot-cupboard.

Each area can be operated individually or in combination,
by means of three green-illuminating rocker switches.

Hotcupboard

Switching on lowest rocker switch operates hotcupboard.

The appliance is supplied with a digital controller that
displays cupboard temperature.

To maintain efficiency, hotcupboard doors should be
closed as soon as trays are inserted or removed.

Controller temperature display will cycle above and below
the set temperature by ± 15°C approximately.

Set temperature can be adjusted if required.

To adjust hotcupboard set temperature, press “set” on
controller and adjust temperature using ▲ or ▼ keys.

Press “set” to return to temperature display.

Bains-Marie

Switching on the middle green-illuminating rocker switch
operates the bains-marie.
The bains-marie is a dry-well type, therefore no water is
required in the well. The hob apertures will accommodate
gastronorm trays up to 150mm deep.

For best practice and maximum efficiency;

• trays should be in place when the bains-marie
is operated.

• tray lids should be used whenever possible,
and removed only when service is imminent.

The bains-marie temperature is preset to maintain a hot
food temperature above a minimum of 76°C.

Overhead Gantry

The top green-illuminating rocker switch operates the
gantry lamps.
These are used to heat the ambient air above food
containers.

SECTION 3 ­CLEANING and MAINTENANCE

The unit must never be cleaned with a water jet or
pressurised spray.

Always switch off and disconnect from mains before
cleaning and allow appliance to cool before cleaning.

Clean using hot, soapy water and a soft cloth.