Falcon 4.3” Digital Wireless Reversing Camera Kit User Manual

4.3” Digital Wireless Reversing Camera Kit

User Manual

www.falcontechnology.co.uk

Thank you for purchasing the Falcon 4.3” Wireless Camera Kit. These instructions tell you how to
operate and get the best from your new camera.

1. Attaching the camera to your vehicle

The base of the camera is magnetic, if you have a suitable steel surface you can attach the camera
directly to that.

If you don’t have a suitable steel surface you can attach the included white steel plate to your
vehicle using the included adhesive or other adhesive of your choice an then attach the camera to
that.

Attach steel
plate to vehicle
using adhesive

Magnetic base
of camera sticks
to steel plate

2. Operation

Press the power button on the camera for 2 seconds until you see a steady blue light (to power the
camera off press the button again for 2 seconds).

Attach the monitor to a cigarette lighter socket in the vehicle. To power on/off the monitor press the
power button for 3 seconds.

When the monitor and the camera are linked the blue light on the camera and the blue light on the
monitor will both flash.

Note: If the signal from the camera is lost or the camera is turned off the monitor will go into
standby mode 10 seconds after the camera is turned off (screen off, blue light on) and will turn back
on again automatically once the camera is turned back on or brought back into range.