Fairfield The Barbershop SPECIFICATION SHEET

Product Name: The Barbershop Product description: Less is more with this simple, original design. Handmade
from JFETs matched to specs, this versatile pedal will treat your pickups with the respect they deserve. In return, they’ll thank you with some of them sweet tones.
TOP SIDE
SAG VOLUMEDRIVE
FAIRFIELD CIRCUITRY 00013
5.25”
SPECIFICATION SHEET
9VDC
3.75”
IN OUT
1.75”
5.25”
Drive:
Sets the interstage gain of the amplifiers. More gain means more distortion.
Sag:
The Sag control reduces the voltage to the amplifiers as you turn it counter clockwise, giving additional control over the character and feel of the saturation. The lower the Sag, the browner the sound. Full voltage is applied when the control is set fully clockwise. It is at this setting that the pedal has the potential to be its cleanest and loudest.
Volume:
Controls the output volume of the pedal while keeping the effect unchanged.
Power:
The Barbershop Overdrive can be powered by either a 9V battery or a typical 9V AC/DC adapter (9VDC, center negative).
Like most pedals, the input is switched in order to turn the pedal ON when a 1/4” jack is in place. If using a battery, to avoid draining it unnecessarily, always unplug the IN jack when not in use.
TIPS
Watch the Volume
It’s best to start with the Volume control at a minimal setting to avoid damage to your ears and equipment.
Find the sweet spot
There are combinations of settings that will put your setup right on the edge of breaking up, allowing you to go from clean to saturated with only variations in playing dynamics.
The sounds that I get out of it are
very clear and are essentially tonally
TECHNICAL SPECIFICATIONSCONTROLS
Input Impedance:
1 Mohm
Output Impedance:
0.34 ohms
Power Consumption:
• Engaged: 5 mA
• Bypassed: 1 mA
Frequency Response:
45 Hz - 45 KHz +- 3 dB
- Joel Cluff -
similar to the sound I get when
I turn my vibro champ to 10.
Extended Warranty:
Fairfield Circuitry will repair or replace any malfunctionning product for a period of 2 years after purchase date. Problems resulting from modifications or misuse may cancel this warranty. All shipping expenses will be covered by the owner. This warranty applies only to original owner of the product. Proof of purchase will be required. Contacting us before sending the defective product is highly recommended.
Fairfield Circuitry
CONTACT
T. +1.819.700.2264 info@fairfieldcircuitry.com
WWW.
FAIRFIELDCIRCUITRY
.COM
Loading...