Factory Direct Hardware 83T143 User Manual
Concealed Teck®Flush Valves
Delta reserves the right (1) to make changes in specifications and materials, and (2) to change or discontinue models, both without notice or obligation.
Dimensions are for reference only. See current full-line price book or www.specselect.com for finish options and product availability.
DST–83T140
Refer to www.specselect.com for individual models. Note: Use this page as a product submittal sheet.
Engineer/Architect Approval
Model Specified:
Approval: Date:
Note: Measurements may vary ± 6mm (0.25'')
Approvals:
• CSA certified
• Complies to ASSE 1037
• Oscillating Lever Handle ADA compliant
and meets Handicapped Accessibility Standard
ASME A117.1 of less than 5 lbs. operating force.
• IAPMO Listed
(Contact Delta Representative for State and/or Local
Approvals.)
83T141
OPTIONAL HANDLE
LOCATION #1
83T141
OPTIONAL HANDLE
LOCATION #2
610mm (24”)
121mm
(4.75”)
254mm
(10”)
292mm
(11.5”)
121mm (4.75”)
102mm
(4”)
318mm
(12.5”)
292mm
(11.5”)
0 - 343mm (0-13.5”)
365mm
(14.5”)
254mm
(10”)
0-343mm
(0-13.5”)
610mm
(24”)
#2
#1
-1 OPTION TRAP SEAL PRIMER TEE
DETERGENT/DISINFECTANT
3/8" O.D. Copper Tube
(NOT SUPPLIED)
TO TRAP
SEAL
Note: For high and low pressure applications, please see page FEA-81T High Water
Pressure note for more details.
Verify flow requirements with bowl manufacturer.
83T141
83T000
Specification: (example)
(FOR 1-1/2'' WALL HUNG BACK INLET CLOSET FIXTURE)
• Quiet action, TECK®concealed diaphragm flush valve
• Chloramine resistant diaphragm
• Forged brass diaphragm retainer
• Renewable seat
• External water conserving flush volume adjustment,
(except -48 and -6 models) factory set at 60 PSI to 6 litre
(1.6 US gal.)
• “Non hold open” metal handle actuator
• Vandal resistant handle control can easily be located and installed
anywhere within 6m (20') of flush valve
• Standard flush valve will install on all walls zero to 343mm
(13-1/2'') thick
• 1'' FIP/copper sweat inlet adaptor
wheel handle angle check stop
• Adjustable 121mm (4-3/4'') plus or
minus 11mm (7/16'') inlet/valve
outlet centers
• Vacuum breaker
❏ 83T140
with 16mm (5/8'') dia. push button
❏ 83T141
with oscillating handle
❏ 83T143
with 35mm (1-3/8'') dia. push button
(FOR BACK INLET PRISON FIXTURE)
❏ 83T000
Same as 83T140 with 16mm (5/8'') dia.
push button BUT with 1-1/2'' MIP on
outlet tube for Prison Fixture installation
OPTIONS: Add dash number to
end product required above.)
-1 Trap seal primer tee
-6 Factory set 6 litre (1.6 US gal.) flush
Not Field Adjustable
-48 Factory set 4.8 litre (1.27 US gal.) flush
Not Field Adjustable
TECK
®
COMMERCIAL
Loading...