Factory Direct Hardware 39882 User Manual

Installation Instructions / Warranty

FIX FIT STOP

Montreux

16882XX1

Starck

10882XX1

Terrano

37882XX1

Citterio

39882XX1

Montreux

16883XX1

Phoenix

17982XX1

37883XX1

39883XX1

Terrano

Citterio

Carlton

17882XX1

Phoenix

17983XX1

Carlton

17883XX1

Steel

35882801

Uno

38882XX1

27452XX1

2

This unit requires a 1/2" NPT male nipple,
extending 7/16" outside the surface of the
finished wall.

Seal the wall around the nipple
with waterproof sealant.

Failure to seal the wall can lead
to possible water damage.

Wrap the nipple with Teflon tape (1).

Position the flat seal over the nipple. Screw the
elbow firmly onto the nipple (2). Test for leaks.

Slide the cover over the elbow and snap into
place on the gasket (3).

Handle assembly

10882XX1 Starck
37882XX1 / 37883XX1 Terrano
16882XX1 / 16883XX1 Montreux

Push the handle onto the stem (1).

Tighten the screw (2).

Install the screw cover (3).

Install the hose adapter and washer (4).

17885XX1 /17886XX1 Carlton
17982XX1 / 17983XX1 Phoenix

Push the handle onto the stem (1).

Tighten the screw (2).

Install the hose adapter and washer (3).

35882801 Steel
38882XX1 Uno
27452XX1

Tighten the screw by hand only three turns (1).

Snap on the handle (2).

Tighten the screw (3).

Cover the hole with the plastic cap (4).

Install the hose adapter and washer (5).

Citterio 39882XX1 / 39883XX1

Install the handle fixation and tighten the screw
(1).

Snap on the handle (2).

Tighten the set screw with a 2 mm Allen
wrench (3).

Install the hose adapter and washer (5).

3