Factory Direct Hardware 39454 User Manual

Installation / Warranty

Citterio

39454XX1

10/2003 9.05014.01

Axor Citterio four-hole roman tub set 39454XX1

Technical Data

Flow rate @ 45 psi 6.0 gpm per side Handshower 2.5 gpm max. Maximum water pressure 145 psi Recommended water pressure: 14.5 - 75 psi Recommended hot water temp.: 120

*Some municipalities limit the maximum water temperature from the water heater to 120o or below. Please know and follow all applicable local codes when setting the temperature on the water heater.

F - 140oF*

Installation Considerations

• Roman tub rough 13444181must be installed, and the finished deck

surface must be complete before this trim kit can be installed.

• Backflow preventer cartridge 94146000 is included with this kit, and

must be used to provide protection from back siphonage. It is already installed on the 94148000 inner Secu-flex hose.

The 13444181 roman tub rough is listed by IAPMO.

Installation Instructions

The water supply must be turned off at the main prior to installation of this kit.

• Remove the plastic plaster shields from

the valves and the spout tee. Use a phillips head screwdriver to remove the screws from the white plastic handle snap connectors. Remove the snap connectors.

• Press the diverter firmly into place in the

spout tee. Remove the cold cartridge.

• Install the new cold cartridge included

with the trim kit.

• Pull upward on the handshower holder

plaster shield. Pull the outer Secu-flex hose completely away from the deck. Unscrew the white plastic winged nut from the bottom of the Secu-flex hose. Put the outer hose away in a safe location. Be extremely careful to prevent the high pressure hose from falling back beneath the tub.

• Remove the brass plug from the end of

the high pressure hose. Attach the chrome inner Secu-flex hose. Use the enclosed Hansgrohe Color towelette to clean and lubricate the inner hose. Have a co-worker use the towelette to clean and lubricate the ends of the outer hose. If the towelette is missing, use a soft cloth sprayed with a silicon lubricant.

• Disassemble the handshower holder as

shown in the diagram. Feed the inner hose through the outer hose. Secure the outer hose at the bottom with the white plastic winged nut. Remove the plaster shield. Compress the outer hose so that the hose end connection can be grasped.

• Feed the hose end connection through

the handshower holder. Snap the two halves of the white plastic retainer over the inner hose. Slide the finished hose retaining ring over the end of the hose and the white plastic hose retainer. Screw it into the handshower holder.

+ 8 hidden pages