Factory Direct Hardware 39143 User Manual

Installation / Warranty

Citterio

39143XX1

Citterio

39147XX1

90614701 5/2005

Axor Citterio Wall Mount Lav Mixer with Cross Handles
39143XX1
Axor Citterio Wall Mount Lav Mixer with Lever Handles
39147XX1

39143XX1 39147XX1

Technical Data

Flow rate @ 45 psi 2.2 gpm
Maximum water pressure 145 psi
Recommended water pressure: 14.5 - 75 psi
Recommended hot water temp.: 120

o

F - 140oF*

*Some municipalities limit the maximum water temperature from the water heater to 120o or
below. Please know and follow all applicable local codes when setting the temperature on the
water heater.

Installation Consideration

Rough-in 10303181 must be installed, and the wall finished, prior to installa­tion of this trim kit.

For the trim to fit properly, the outside surface of the finished wall must fall
between the “minimum” and “maximum” lines on the factory installed plaster
shields on the rough-in. If the rough-in is too far inside the wall, install
extension kit 96259000 before attempting to install the handle trim.

No drain is included with this trim kit. Please consult the sink manufacturer
regarding a suitable drain for the specific sink used.

· Pull the inserts from the plaster
shields on the hot and cold rough­in valves.

· Trim the plaster shields on the hot,
cold, and spout to 1/16” from the
finished wall.

· Lever handle model only:
Use a 17 mm deep socket wrench
to remove the cartridges from the
rough-in. Install the new ¼ turn
ceramic cartridges included with
the trim kit. The new hot cartridge
is marked with notches on the
wrench flats.

· All models: Install the white
plastic threaded sleeve to the hot
and cold sides of the valve. Use
a ruler to measure a point on the
sleeve 3/8” from the surface of
the finished wall. Mark the sleeve
at that point. Cut the sleeve.
Insert the inner sleeve.

· Use a ruler to measure to a point
on the inner sleeve ½” from the
surface of the finished wall. Mark
the inner sleeve at that point. Cut
the inner sleeve. Push the handle
into place.

· The handle should be parallel to
the floor. If it is not, remove it.

· Remove the handle insert from the
handle. Turn it slightly and
reinsert it.

· Replace the handle. It should
now be parallel to the floor.

· Remove the handle. Push the
escutcheon over the outer sleeve.
Place the handle over the valve.
Turn the handle base clockwise,
so that it threads onto the outer
sleeve.

Install the spout.

· Use a ruler to measure from the
metal part of the spout port to
the outside edge of the plaster
shield. Record the measurement
(“x”). Add 1 7/8”. Record this
measurement. Measure the
spout connector from the outlet
end to a pout X + 1 7/8”. Mark
the spout connector at this point.
Cut it. The total length of the spout
connector should be X + 1 7/8”.

· Wrap the threads on the spout
connector with several layers of
Teflon® thread tape. Screw the
spout connector into the port.

· Measure the spout connector. It
should extend from the plaster
shield 1 3/8”.

· Place the spout escutcheon over
the spout connector. Press the
spout over the spout connector.
The pin on the back of the spout
should align with the detent on the
spout escutcheon. Tighten the set
screw on the bottom of the spout.

User Instructions – Lever handle version

· Turn the handle downwards
(clockwise for cold, counter­clockwise for hot) to turn the water
on. Turn the handle upwards to
turn the water off.

· In the off position, the handles should be parallel to the floor.

Replacement parts

1 Lever handle 39396XXX
2 Cross handle 39295XXX
3 Hot escutcheon 96755XXX
4 Cold escutcheon 96754XXX
5 Spout escutcheon 96756XXX

6 Aerator 13085000
7 Mounting set 96392000
8 Hot cartridge 96351000
9 Cold cartridge 96350000
10 Extension kit (optional) 96259000

Cleaning Recommendation for Hansgrohe Products

Modern faucetry and shower products utilize a combination of materials to comply with the needs of the
market with regard to design and functionality.

To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper
treatment is not covered under the Hansgrohe warranty.

Cleaning Materials for Faucets and Showers

• To remove lime scale, use only products made specifically for that purpose. Always follow the
manufacturer’s instructions when using.

• Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will
cause considerable damage to finishes and to plastic components.

• Never mix cleaning materials.

• Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.

Cleaning Procedures

• Clean your faucets and shower products as and when required. Regular cleaning will prevent scale
buildup and water spotting.

• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than
necessary.

• When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the
product.

• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.

Important

• Soap and shampoo residue can also cause damage to the product. Rinse well with clean water
after use.

• If the surface is already damaged, harsh cleaning materials will cause further damage.

Limited Lifetime Consumer Warranty

This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc.
(“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in
the United States after March 1, 1996, and installed in either the United States or Canada.

WHO IS COVERED BY THE WARRANTY

This warranty extends to the original consumer purchaser only.

WHAT IS COVERED BY THE WARRANTY

This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product
against defects in material or workmanship as follows: Hansgrohe will repair at no charge for parts only
or, at its option, replace any product or part of the product which proves defective because of improper
workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe
is unable to provide a replacement and repair is not practical or cannot be timely made, Hansgrohe
may elect to refund the purchase price in exchange for the return of the product.

LENGTH OF WARRANTY

Replacement or repaired parts of products will be covered for the term of this warranty as stated in the
following two sentences. If you are a consumer who purchased the product for use primarily for
personal, family, or household purposes, this warranty extends for as long as you own the product and
the home in which the product is installed. If you purchased the product for use primarily for any other
purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year,
with respect to Interaktiv and Retroaktiv products, and (ii) for 5 years, with respect to AXOR, ShowerPower
and Pharo products.

THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:

A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.

B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse,

abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse”
cleaning products, or the use of the product in any manner contrary to the product instructions.

C. Labor or other expenses for the disconnection or return of the product for warranty service, or for installation

or reinstallation of the product.

D. Accessories or related products not manufactured by Hansgrohe.

TO OBTAIN WARRANTY SERVICE

Contact your Hansgrohe retailer, or write to Technical Service at:

Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004

Or, call Hansgrohe toll-free at [phone].

In requesting warranty service, you will need to provide

1. The sales receipt or other evidence of the date and place of purchase.

2. A description of the problem.

3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to
Hansgrohe Inc. 1492 Bluegrass Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service,
if required by Hansgrohe.

When warranty service is completed, any repaired or replacement product or part will be returned to you postage
prepaid.

EXCLUSIONS AND LIMITATIONS

REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE)
AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER.
HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY
OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.

HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL,
SPECIAL, OR CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR
ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).

Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
or exclusion may not apply to you.

This warranty gives you specific legal rights, and you may have other rights which vary from State to State.

You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before
you can bring any action in court against us under the Magnuson-Moss Warranty Act.

PRODUCT INSTRUCTIONS AND QUESTIONS

Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible
defect. Prior to installing, always carefully study the enclosed instructions on the proper installation and the care
and maintenance of the product. If you have questions at any time about the use, installation, or performance of
your Hansgrohe product, or this warranty, please call or write to us at the toll-free number and address printed
above.

Hansgrohe Inc.

1490 Bluegrass Lakes Parkway

Alpharetta GA 30004

770 360 9880

website: www.hansgrohe-USA.com