Factory Direct Hardware 39115 User Manual
Installation Instructions / Warranty
Axor Citterio
39115XX1
2
Axor Citterio Wall-Mount Lavatory Trim
39115XX1
Technical Data
Max. water pressure 145 psi
Recommended pressure 14.5 - 72 psi
Recommended hot water temp 120°F - 140°F*
Flow rate 1.5 gpm
The hot and cold supplies must be of equal pressure for proper operation of the faucet.
*Know and follow all applicable local codes when setting the temperature of the water heater.
Installation Considerations
Rough-in 38111181 (purchased separately) must be installed and the finished wall complete
•
before installation of this trim kit. The outside surface of the finished wall must fall between the
"min" and "max" lines on the plaster shields. If the valve is too far inside the wall, purchase
extension kit 38982000 before attempting to install this trim kit.
For best results, Hansgrohe recommends installation by a licensed, professional plumber.
•
No drain is included with this faucet. Contact the manufacturer of the sink for recommenda-
•
tions regarding suitable drains.
Recommended tools (not included)
27 mm & 17 mm deep sockets
12 mm allen wrench
Teflon tape
cutting tools
waterproof sealant
Installation Instructions
Turn off the water at the supply before beginning the
installation.
Remove the caps from the plaster shields. Cut the
plaster shields 1 mm (1/16”) from the surface of the
finished wall. Seal around the plaster shields with
waterproof sealant.
Use a 27 mm deep socket wrench to remove the flush
insert.
Use a 17 mm deep socket wrench to remove the plug
from the spout port.
Install the cartridge and anti twist device to the
cartridge housing. Make sure that the cartridge is
oriented as shown in the diagram.
3
4
Install the springs and cup washers in the valve body.
Install the cartridge assembly.
Install the handle. Tighten the set screw using the enclosed 2 mm allen wrench.
Measure the distance from the surface of the finished
wall to the end of the handle.
X
Loading...