Factory Direct Hardware 39010 User Manual
Installation Instructions / Warranty
Axor Citterio
39010XX1
39200XX1
2
Axor Citterio Lav Mixer 39010XX1
Axor Citterio Bidet Mixer 39200XX1
39010XX1 39200XX1
Technical Information
Recommended water pressure 14.7 - 72.5 psi
Recommended hot water temp. 120� - 140� F*
Max. hot water temp 165�F*
Hole size in mounting surface 1 3/8"
Max. mounting surface depth 1 1/2"
Flow rate -- lavatory 1.5 gpm
Flow rate -- bidet 2.2 gpm
3/8" supply hoses - requires 3/8" compression fitting (not
included)
*Please know and follow all applicable local plumbing codes when setting
the temperature on the water heater.
Installation Considerations
For best results, Hansgrohe recommends that this unit
•
be installed by a licensed, professional plumber.
Please read over these instructions thoroughly before
•
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
Caution: Do not bend or twist
the supply hoses!
Installation
Place the faucet, escutcheon, and sealing ring on the
mounting surface.
Install the fiber washer, friction washer, and mounting
nut.
Orient the faucet as desired, then tighten the mounting
nut. Tighten the tensioning screws.
Connect the hoses to the stops, using 3/8" compression fittings (not included). Use two wrenches, as
shown, to prevent the hoses from twisting.
Do not allow the supply hoses to
twist.
Twisted supply hoses may become
loosened from the faucet, which
may cause water damage.
Install the drain.
Turn on the water and check all connections for leaks.
3
Loading...