Factory Direct Hardware 10050 User Manual
HANSGROHE PRODUCT SERVICE
TWO HANDLE LAV MIXER
TWO HANDLE HIGHRISER
TWO HANDLE BIDET MIXER
Ref. No.: 10030XX1/10050XX1/
10058XX1/10230XX1
Installation
Starck
Assembly
1. Flush pipe lines thoroughly.
2. Place the mixer including the sealing washer in position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over the threaded base and tighten the collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the supply valves: hot-left; cold-right.
6. Connect the lift rod to the pop-up waste assembly (only 10030XX1, 10050XX1 and 10230XX1).
Large differences in pressure between the hot and cold water supply should be balanced.
Technical data
Lav Mixer 10030XX1 Bidet Mixer 10230XX1
Mounting
hot cold
Hole size in deck:
Minimum: 1 1/4"
Maximum: 1 5/8"
max. 1¾"
Highriser 10050XX1
Highriser 10058XX1 without lift rod and
pop-up waste
Operating pressure : max. 147 psi
Recommended operating press. : 14.7 - 72.5 psi
Test pressure : 232 psi
Hot water temperature : max. 176° F
Recommended hot water temp. : 149° F
08/2004
HANSGROHE PRODUCT SERVICE
Spare parts
10030XX1/
10050XX1/
10058XX1
6
2
3
1
4
5
10230XX1
1 Handle for cold / hot water 96318XXX
2 Color-ring cold / hot water 96319000
3 Handle fixing set 94184000
4 Stop unit
10030XX1/10050XX1/
10058XX1 94009000
Stop unit
10230XX1 94149000
5 Aerator 94005XXX
6 Lift rod 94083XXX
7 Tube for lav/bidet mixer 30622210
Tube for Highriser 30630910
8 Fixation set 13961000
XXX = Color code: 000
chrome
810 satinox
7
5
8
Cleaning Recommendation for Hansgrohe Products
Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and
functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the
Hansgrohe warranty.
Cleaning Materials for Faucets and Showers
• To remove lime scale, use only products made specifically for that purpose. Always follow the manufacturer’s instructions when using.
• Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause considerable damage to finishes and
to plastic components.
• Never mix cleaning materials.
• Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.
Cleaning Procedures
• Clean your faucets and shower products as and when required. Regular cleaning will prevent scale buildup and water spotting.
• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than necessary.
• When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the product.
• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
• Soap and shampoo residue can also cause damage to the product. Rinse well with clean water after use.
• If the surface is already damaged, harsh cleaning materials will cause further damage.
08/2004
Loading...