Factory Direct Hardware 06438 User Manual

Installation Instructions / Warranty

Interaktiv

06438XXX

Interaktiv Hose Pull-Out Set
06438XXX

Technical Specification

Maximum mounting surface thickness 1 1/2"
Hole size in mounting surface 1 1/2"
Protection against back siphonage provided by a check
valve installed in the elbow.

Installation Consideration:

The mounting surface must be complete and made water­tight prior to installation of this unit.

Installation

Unscrew the handshower holder escutcheon. Remove the
insert. Put both pieces in a safe place.

Place the handshower holder and sealing ring in place on
the mounting surface (1).

From below the mounting surface, install the friction washer,
metal washer, and mounting nut (2).

Tighten the mounting nut (3). Tighten the tensioning screws
(4).

2

Push the elbow firmly over one end of the handshower
hose (1). Tighten the hose nut (2).

From the top, thread the hose through the handshower
holder escutcheon and handshower holder (1). Snap the
two halves of the hose insert around the hose (2). Press
the hose insert down into the holder. Install the escutch­eon (3).

Seal the threads on the inlet end of the high pressure
hose with Teflon tape. Install this end of the hose to the
outlet on the mixing valve.

Connect the handshower hose to the high pressure hose.

3