Factory Direct Hardware 06120 User Manual

Installation Instructions / Warranty

3-Hole Roman Tub Rough

3-Hole Roman Tub Trim Kits

3-Hole Roman Tub Rough
06607000

Technical Specification

Recommended operating pressure 45 - 80 psi
Recommended hot water temp. 120o - 140o F*
Max. flow rate 10 gpm
Hole sizes
valves 1 1/4”
spout 1 3/8”
spout pin 3/16”
Max. mounting surface thickness 1 9/16”
Requires 1/2” supply lines (not included)

*Please know and follow all applicable local plumbing codes when setting the temperature on the
water heater. In Massachusetts, the water heater may be set no higher than 112oF.

Installation Considerations

For best results, this unit should be installed by a licensed, professional plumber.
Large differences in pressure between the hot and cold supplies should be balanced.
The included connecting tubes are type “K” copper tubing. If an installation different from

the one shown here is desired, the plumber may provide his own copper tubing.
To insure proper fit of the trim, this valve should be installed after the mounting surface is

finished and made watertight.
The hot and cold water supplies should be flushed thoroughly before installation of this

rough valve. Damage to the cartridges caused by debris is not covered by the warranty.

2

Installation

Install the connecting tubes: Place a compression nut

and ferrule on one end of the connection tube. Push the
tube into the inlet of the spout tee. Tighten the compression
nut. Place another compression nut and ferrule on the other
end of the compression tube. Push the tube into the outlet
port of the valve. Tighten the compression nut. Repeat with
the second connection tube.

Install the rough: Remove the
plaster shields, escutcheon adapt­ers, o-rings, and stop rings from the
valves.

Remove the plaster shield, spout
adapter, and spout adapter gasket
from the spout tee. If the mounting
surface is unusually, thin, leave
the white plastic spacer in place.
Otherwise, it may be removed and
discarded.

If necessary, reinstall the o-rings to
the corresponding grooves on the
escutcheon adapters.

Insert the valves and spout tee through the corresponding holes in the mounting surface.
Install the stop rings and escutcheon adapters. When installed properly, the stop rings will
stop the escutcheon adapters at the proper mounting height.

Lower the valves so that the escutcheon adapters rest on the mounting surface.
Slide the spout adapter gasket over the spout tee, aliging the hole in the gasket with the re-

taining pin hole on the mounting surface. Install the spout adapter. The pin on the adapter
should go through the hole in the mounting surface.

Tighten the mounting nuts and tensioning screws.

Reinstall the plaster shields. Leave them in place until
the trim is to be installed.

3

Interaktiv and Retroaktiv Trim, 3-Hole Roman Tub Sets

Models Covered

Interaktiv

Solaris 06630XX0
Stratos 06574XX0
Metro 06551000
Interaktiv S 06875000

Retroaktiv

Swing Tango Limbo
Cross handle 06122XX0 06045XX0 06109XX0
Scroll handle 06120XX0 06044XX0 06108XX0
Lever handle 06120XX0 06043XX0 06107XX0

These trim kits are for use with rough 06607000. The rough must be installed, and the
mounting surface complete and watertight.

Interaktiv (Metro handles shown)

Retroaktiv Swing (cross handles shown)

4

Retroaktiv Tango (scroll handles shown)

Retroaktiv Limbo (lever handles shown)

5

Install the Handles

Retroaktiv only: Install the deco-rings on the handles.

All models: Remove the plaster shields from the hot and

cold valves and spout tee.

Position the handle over
the sten with the lever in
the desired “off” position.
While holding the lever
with one hand, use the
other hand to turn the bell,
and screw it down over
the valve.

Install the spout:

Retroaktiv Swing only: Install the deco-ring on the spout. Make sure that the set screw

hole in the deco ring lines up with the set screw hole on the spout.

All models: Remove brass plug from the spout tee.

6

Push the spout sealing ring
firmly into the spout tee.

Press the spout over the
spout tee. Install and
tighten the set screw with
the enclosed 3 mm Allen
wrench.

Turn on the water and check all connections for leaks.

User Instructions:

Turn the left handle to obtain hot water, the right handle to obtain cold water.
If the flow of water diminishes over time, remove and clean the aerator.

7

Replacement Parts

3

1

5

06607000

1 hot cartridge 94009000
2 cold cartridge 94008000
3 mounting kit 88511000
4 mounting kit 88540000
5 compression ftg 88513000

6

2

4

6 valve set 88503000
7 sealing ring 88512000
8 aerator 13956XXX
9 set screw 96029000
10 Solaris handles 06850XXX
11 Stratos handles 06852XXX
12 Metro handles 06853XXX
13 Interaktiv S handles 06957XXX
14 cross handles, tall 06326XXX
15 scroll handles, tall 06325XXX
16 lever handles, tall 06324XXX
17 cross handles, low 06305XXX
18 scroll handles, low 06304XXX
19 lever handles, low 06303XXX
20 handle deco ring 88600XXX

Interaktiv

9

10

7

11 12

8

8

13

Retroaktiv

14

20

20

9

9

8

15

7

16

Swing

8

7

Tango

Limbo

20

17

9

18

19

7

8

9

Cleaning Recommendation for Hansgrohe Products

Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market
with regard to design and functionality.

To avoid damage and returns, it is necessary to consider certain points when cleaning:

Cleaning materials for faucets and shower products:

Acids are necessary ingredients of cleaning materials for removing lime. However, please pay attention to the
following points when cleaning faucets and shower products:

• Use only cleaning materials intended for the application.

• Never use cleaning materials which contain hydrochloric, formic, or phosphoric, or acetic acid, as these can

cause considerable damage.

• Do not mix one cleaning material with another.

• Do not use abrasives, such as cleaning powders, sponge pads, or microfiber cloths.

Cleaning Instructions for Faucets and Shower Products:

Please follow the cleaning material manufacturer’s instructions. In addition, please note the following:

• Clean your faucets and shower products as and when required.

• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than necessary.

• Regular cleaning will prevent scale buildup and water spotting.

• When using spray cleaners, spray first onto a sponge or cloth. Do not spray directly onto the faucet or shower

product as drops could enter openings or gaps and cause damage.

• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.

Important

Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note:

• If the surface is already damaged, the effect of cleaning materials will cause further damage.

• Components with damaged surfaces must be replaced, otherwise, this could cause injury.

• Damage caused by improper treatment will not be covered by our warranty.

Limited Lifetime Consumer Warranty

This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This
warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and
installed in either the United States or Canada.

WHO IS COVERED BY THE WARRANTY

This warranty extends to the original consumer purchaser only.

WHAT IS COVERED BY THE WARRANTY

This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material
or workmanship as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of
the product which proves defective because of improper workmanship and/or material, under normal installation, use, service
and maintenance. If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made,
Hansgrohe may elect to refund the purchase price in exchange for the return of the product.

LENGTH OF WARRANTY

Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences.
If you are a consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty
extends for as long as you own the product and the home in which the product is installed. If you purchased the product for
use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1

10

year, with respect to Interaktiv and Retroaktiv products, and (ii) for 5 years, with respect to AXOR, ShowerPower and Pharo
products.

THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:

A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse,

negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products,
or the use of the product in any manner contrary to the product instructions.

C. Labor or other expenses for the disconnection or return of the product for warranty service, or for installation or

reinstallation of the product.

D. Accessories or related products not manufactured by Hansgrohe.

TO OBTAIN WARRANTY SERVICE

Contact your Hansgrohe retailer, or write to Technical Service at:
Hansgrohe Inc.

1492 Bluegrass Lakes Parkway
Alpharetta GA 30004

Or, call Hansgrohe toll-free at [phone].
In requesting warranty service, you will need to provide

1. The sales receipt or other evidence of the date and place of purchase.

2. A description of the problem.

3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc.
1492 Bluegrass Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.

When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.

EXCLUSIONS AND LIMITATIONS

REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER
THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES
ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.

HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR
CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING
MERCHANTABILITY).

Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.

This warranty gives you specific legal rights, and you may have other rights which vary from State to State.
You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring

any action in court against us under the Magnuson-Moss Warranty Act.

PRODUCT INSTRUCTIONS AND QUESTIONS

Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect.
Prior to installing, always carefully study the enclosed instructions on the proper installation and the care and maintenance of
the product. If you have questions at any time about the use, installation, or performance of your Hansgrohe product, or this
warranty, please call or write to us at the toll-free number and address printed above.

11

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004

Tel. [phone] • Fax [phone]

www.hansgrohe-USA.com

US - Installation Instructions • Part No. 90964701 • Revised 01/2007