Factory Direct Hardware 06096 User Manual

Installation Instructions / Warranty

Accessories

Interaktiv and Retroaktiv Accessories

These instructions cover the following models:

Accessory Interaktiv Retroaktiv

Tumbler w/holder 06589XX0 06090XX0
Soap dish w/holder 06592XX0 06091XX0
Soap dispenser 06593XX0 06092XX0
Toilet paper holder 06596XX0 06093XX0
Toilet brush 06600XX0 06094XX0
Towel ring 06596XX0 06095XX0
Hook 06594XX0 06096XX0
Robe hook 06595XX0 06099XX0
12” Towel bar 06598XX0 06097XX0
24” Towel bar 06866XX0 06098XX0

Interaktiv Accessories

Soap Dispenser

06593XX0

Toilet Brush
06600XX0

2

Soap Dish

06592XX0

24” Towel Bar

06866XX0

12” Towel Bar

06598XX0

Tumbler

06589XX0

Towel Hook / Toilet

Paper Holder

06596XX0

Robe Hook
06595XX0

Face Cloth Hook

06594XX0

Retroaktiv Accessories

06092XX0

Soap Dispenser

06096XX0

Face Cloth Hook

06099XX0
Robe Hook

06091XX0

Soap Dish

06093XX0

Toilet Paper Holder

06090XX0

Tumbler

06095XX0
Towel Ring

06094XX0
Toilet Brush

06097XX0

12” Towel Bar

06098XX0

24” Towel Bar

3

Interaktiv Accessories

Installation Instructions: 06593XX0 soap dispenser, 06589XX0 tumbler, 06592XX0

soap dish, 06600XX0 toilet brush

Mark the positions of the screw holes on the wall.
Make sure that they are level.

Drill the screw holes using a 6 mm drill bit
suitable for the wall surface.

Install the anchors. Seal around the anchors with
a good quality waterproof bathroom sealant.

Screw the holder mounting bracket into the
anchors. The detent pin on the mounting bracket
should be on the bottom.

Slide the holder cover over the mounting bracket
so that the detent pin on the mounting bracket
clicks into place in the corresponding hole in the
cover.

Place the accessory (soap dish/soap dispenser/
tumbler/toilet brush cup) into the holder.

The accessory may be removed from the holder
for cleaning.

Refilling the soap dispenser

Lift the pump assembly off the bottle. Refill the
bottle. Replace the pump assembly.

4