Factory Direct Hardware 04059860 User Manual

Installation Instructions / Warranty

E

04059XX0

S

04057XX0

Wall-mounted Pot Filler S 04057XX0
Wall-mounted Pot Filler E 04059XX0

04057XX0

04059XX0

2

Technical Information

Recommended water pressure 14.7 - 72.5 psi
Hole size in mounting surface 1 3/16"
Max. wall thickness 1 1/2"
Flow rate 2.2 gpm
This faucet is intended for cold water only.

Installation Considerations

For best results, Hansgrohe recommends that this unit be installed by a licensed, profes-

•
sional plumber.

Please read over these instructions thoroughly before beginning installation. Make sure

•
that you have all tools and supplies needed to complete the installation.

This faucet requires a 1/2" NPT male nipple,

•
extending 1/2" outside the surface of the
finished wall.

Stud supports for the mounting flange must be

•
installed.

Extreme care should be taken to avoid dam-

•
age to hidden electrical or plumbing lines
when drilling the screw holes.

Do not use petroleum based plumbers putty. If

•
desired, seal around the flange with silicone
sealant.

Installation

Wrap the threads on the nipple with Teflon tape.

Install the mounting flange. It should be centered
over the nipple.

Caution: while drilling the screw holes, use
extreme caution not to damage hidden electrical
or plumbing lines.

3