EZLO VC702 User Manual

Congratulations on choosing the VistaCam 702

You’ve taken the next step toward making your home safer and your life easier.
It’s easy to set up your camera. Here’s what you need to do.

1. If you haven’t already set up your Vera controller, please do that first. There are instructions on
how to do so accompanying the controller.

2. Plug in your VistaCam 702. When the LED begins blinking blue, it’s ready to be added to your
Vera system.

3. Follow the prompts in your Vera app to set up the camera.

4. That’s it! Your VistaCam 702 has been set up. The LED will flash slowly confirming it is operating
properly. The status LED can be turned off under the camera’s settings.

Need help setting up?

You can reach our Customer Care team at 866.966.2272 between 6am and 10pm US Central time,
seven days a week, or at [e-mail].

You can also purchase our Vera Easy Start service and get one hour of personalized setup assistance
through a phone call with one of our most experienced agents. Visit getvera.com to learn more.

To find the complete user guide, as well as information about the product’s FCC/IC registration, visit
getvera.com/support and click on “Downloads, Firmware & Manuals.”

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
BATTERY IS NOT USER REPLACEABLE.

Regulatory Information
Camera model VistaCam 702 (SKU:VistaCam-702-US) is designed for indoor use.
FCC Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Note: This product has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This product generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this product does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.
—Consult the dealer or an experienced radio/TV technician for help. Please take attention that
changes or modification not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This equipment should be installed and operated with a minimum distance 20cm between the
radiator and your body.