EZ-ACCESS Pathway Stair System Assembly Manual
Assembly Manual
Pathway® Stair System
For use with the Pathway® Modular Ramp System, as freestanding stair, or
with other structures.
Manufactured in the USA
© EZ-ACCESS®, a division of Homecare Products, Inc. All rights reserved.
All text and images contained in this document are proprietary and may not be shared, modified,
distributed, reproduced, or reused without the express written permission of EZ-ACCESS.
14697 REV 02-15-16
- 2 -
ASSEMBLY MANUAL
Ratchet with 1/2” deep well socket or 1/2” wrench
1/8″ drill bit
5/32″ T-Handle Allen wrench or similar tool
3/16″ Allen wrench
#2 Phillips head screw driver or similar tool
Box knife
25’ tape measure
Level
Rubber mallet
File
Power drill
For EZ-ACCESS® Pathway® Stair System
ATTENTION INSTALLER AND END USER:
For residential use only.
850 lb. weight capacity. Do not exceed weight capacity.
Read and follow all instructions, labels and warnings prior to assembly and use.
Installer, please leave this ASSEMBLY MANUAL with the end user.
When Pathway Stair System is freestanding, all four feet of the stair MUST be securely anchored.
TOOLS TYPICALLY REQUIRED:
SYMBOL MEANINGS:
This is the WARNING symbol . Symbol may appear in various colors and in conjunction with other symbols.
WARNING may be spelled out and not include the symbol. WARNING (word or symbol) indicates a failure, by any
user, to obey that safety warning could result in damage to property and or equipment, as well as serious personal
injury or death to operator and others.
This is the NOTE symbol . Symbol may appear in various colors and in conjunction with other symbols. NOTE
may be spelled out and not include the symbol. NOTE (word or symbol) indicates a failure to obey all notes could
result in improper operation, and, at the sole discretion of the manufacturer, may void your warranty.
WARNING! READ AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE USE!
- 3 -
PROPER SET UP AND USE WARNINGS
Read and follow all labels, instructions, and warnings prior to assembly and use. To obtain a copy of
complete instructions and warnings, call customer service at 1-800-451-1903.
Whenever the Pathway Stair System is freestanding, all four feet of the stair MUST BE securely anchored.
Use caution at all times. Proper maintenance and upkeep to the stair system and all Pathway® system
components is vital. NOTE: The term “system” refers to the entire Pathway Modular Access System,
including, gate, stairs, ramp, platform, risers, handrails, supports, transition plates, landing pad, and any/all
hardware and components.
Regularly check that all parts are in good condition and check the system for damage. Ensure all fasteners
and locking mechanisms are in place and tightened. If any part of the stair system is damaged, loose, or
missing, DO NOT USE UNTIL REPAIRS CAN BE MADE BY A CERTIFIED INSTALLER OR OTHER
QUALIFIED PERSON.
Do not walk, sit, stand, etc. on the system until the installation is complete.
Consult local building codes regarding securing stair system for wind loads.
If user has a mobility concern, or is otherwise not in able-bodied physical condition, ONLY USE STAIR
SYSTEM WITH A QUALIFIED HELPER.
Keep the stair system clear of debris and clutter. Do not use if walking surface is unsafe.
The system may be slippery when wet or icy.
Confirm the stair system is correctly leveled and positioned securely. Periodically check for ground shifts.
Metal conducts electricity. Do not use near exposed wiring or hang lights from stair system.
Never place anything on, under, or attach anything to system.
Only use components supplied or approved by manufacturer with system.
Do not sit, stand, or climb on guards, gates, or handrails.
Do not use handrails, gates, or any other part of the stair system, to support planters, decorations, etc.
Do not play on or around stair system, including, but not limited to, running, jumping, bicycles, scooters,
skateboards, etc.
Properly support and restrain stair system in transit or storage.
At all times, keep the stair system clear of dirt, leaves, and other debris that may accumulate on the
surface. Simply sweeping the system or using a garden hose will usually suffice, but, if needed, a damp
cloth or soft brush with soap and water can be used (avoid alkaloid detergents). Rinse well and use extra
caution when stair system surface is wet.
If system surface is covered with ice and/or snow, DO NOT USE until accumulation is removed and the
tread surface swept clean. Magnesium Chloride salt substitute may be used to melt snow or ice
accumulation. However, after the snow and/or ice threat has cleared, be sure to clean the tread surface
with soap and water (avoid alkaloid detergents) to remove Magnesium Chloride residue. Rinse well and
use extra caution when stair system surface is wet.
Regularly check that all parts are in good condition and check the stair system for damage. Ensure all
fasteners and locking mechanisms are in place and tightened. If any part of the system is damaged, loose,
or missing, DO NOT USE UNTIL REPAIRS CAN BE MADE BY A CERTIFIED INSTALLER OR OTHER
QUALIFIED PERSON.
If stair system is damaged or unstable, DO NOT USE UNTIL REPAIRS CAN BE MADE BY A CERTIFIED
INSTALLER OR OTHER QUALIFIED PERSON.
For additional care, usage, or general safety information, please call 1-800-451-1903.
- 4 -
The Pathway Modular Stair System is designed to work in conjunction with the Pathway Modular Ramp System but
PN
Short Name
Description (w/ Recommended Rises)
Number
of Treads
Rise: Code
Compliant
Rise: NonCompliant
14911
PSS0814
EZ-ACCESS PATHWAY STAIR SYSTEM 8”-14"
1
8”-14”
8”-17.375”
14912
PSS1521
EZ-ACCESS PATHWAY STAIR SYSTEM 15”-21"
2
15”-21”
15”-24.375”
14913
PSS2228
EZ-ACCESS PATHWAY STAIR SYSTEM 22”-28"
3
22”-28”
22”-31.375”
14914
PSS2935
EZ-ACCESS PATHWAY STAIR SYSTEM 29”-35"
4
29”-35”
29”-38.375”
14915
PSS3642
EZ-ACCESS PATHWAY STAIR SYSTEM 36”-42"
5
36”- 42”
36”- 45.375”
14916
PSS4349
EZ-ACCESS PATHWAY STAIR SYSTEM 43”-49"
6
43”-49”
43”-52.375”
14917
PSS5056
EZ-ACCESS PATHWAY STAIR SYSTEM 50”-56"
7
50”-56”
50”-59.375”
can be used as a standalone stair on an existing porch or deck. There are seven models which cover different
height ranges from 8” to 59-3/8”. See below for descriptions and height ranges. Each stair will include two side rails,
two legs, the number of treads needed for the height range and posts, handrail tubes and tube connectors.
USAGE NOTES:
When properly anchored, the Pathway Modular Stair System may be used as a freestanding stair.
The Pathway Modular Stair System may also be attached to existing platforms, decks, or other suitable structures.
INSTALLATION/CONFIGURATION WARNING:
Installing the Pathway Stair System in any non-compliant configuration, or rise, may result in an unsafe situation and
or installation being rejected by your local inspector or AHJ. Always check your local codes and assemble in
compliance. Consult your local contractor for assistance.
CONFIGURATIONS CHART ( SEE “INSTALLATION/CONFIGURATION WARNING” ABOVE)
When connected to a platform in the Pathway Modular Ramp System, the stair will commonly be used with at least
one Platform Handrail to Stair Connector (MHRPSC).
- 5 -
Refer to the Pathway Modular Ramp System assembly manual for all instructions not covered in this manual for
PATHWAY STAIR SYSTEM
Pathway Stair System 22”-28” (shown without stair support tubes and feet).
OPTIONAL: MHRPSC
(CONNECTOR – HR PLATFORM TO HR STAIR)
OPTIONAL: PSSLPxxxx
FEET & LEG PAIRS
This kit is used to connect the stair handrails to the
platform handrails. The supplied 36” handrail tubes
are cut to length during installation.
This kit is used for additional support at the top of
the stair system or when stairs are being used as a
standalone system.
NOT TO SCALE
the Pathway Stair System.
1. BASIC SYSTEM COMPONENTS
1.1.
Because each installation is different, your system may or may not contain these basic
components.
Loading...