Extron Electronics VGA Termination Kit User Manual
VGA Termination Kit Instructions
Backshell
Jumper
1. On the back of the connector, solder jumper wir es fr om pin 6 to pin 7, from
pin 7 to pin 8, from pin 8 to pin 10, and from pin 10 to the shell (see the pinout
table on the back of this card).
2. Strip away approximately 1" of the outer jacket of the 5-wire coaxial cable.
3. Trim the outer foil shield back to a length of approximately 0.25".
4. For each coax cable:
a. Carefully strip away approximately 0.5" of
the jacket from the end of the coaxial cable
to expose the spiral shield.
b. Twist the spiral shield together and bend
the twist aside.
c. Carefully strip away approximately 0.25" of
the insulation to expose the center conductor .
Outer
Jacket
Foil Shield
Spiral Shield
Outer Foil Shield
1"
1/2" 1/4" 1/4"
Center
Conductor
Insulation
d. Solder the center conductor of the cable to the pin’s
solder cup shown in the table below.
5.T
wist all of the conductors’ spiral shields (from 4b) together
and solder them to pin 10 or to the connector shell
.
6. Fasten the two halves of the backshell together around
the front plate of the connector using the provided
screws and nuts.
Front Plate
Pinout
PinCoax
1Red conductor
6Red shield
2Green conductor
7Green shield
3Blue conductor
8Blue shield
Jumper
11
15
6
1
5
10
68-516-01 Rev. B
Twist all 5 shields
together and solder.
Center
Conductor
Solder Cups
PinCoax
13Black conductor
10Black shield
14Yellow conductor
10Yellow shield
08 08
Coax
Cables
Loading...