VCM 200 EU and VCM 200 MK • Installation Guide
This guide provides instructions for an experienced installer
to install an Extron VCM 200 EU or a VCM 200 MK device.
The VCM 200 EU and VCM 200 MK are remote volume/mute
controllers with a 10k ohm potentiometer and mute button.
They are designed to work solely with any Extron amplifier
product with a remote volume control port, such as the
VOLUME
MUTE
VCM 200 EU
MPA 122 or MPA 401 Mini Power Amplifiers.
The VCM 200 EU devices mount into a single sized European junction box with 60 mm
centers (not supplied). The VCM 200 MK mounts into a 35 mm deep, single MK junction
box. Both models have a matching trim plate for the finished installation.
For product specifications visit www.extron.com.
NOTE: Check that the installation meets the local and national regulatory
requirements, including building, electrical, and safety codes, and UL and
accessibility requirements.
Installation
VCM 200 EU Model —
1. Install a junction box into a Euro channel
or into a wall.
2. Run the cables from the location of the
audio source, such as an MPA.
3. Where needed, in order to make the
device flush with the channel or wall,
place the supplied metal spacer plate
between the adapter plate and the
junction box.
4. Using the supplied screws fasten the metal
adapter plate (and spacer plate if used) to
the junction box (see the image at right).
VCM 200 MK Model —
1. Following the manufacturer’s
instructions, either install a wall box
into wall or secure one to the wall.
2. Run the cables from the audio source
location, such as an MPA.
3. Using the supplied screws fasten the
adapter plate to the junction box (see
the image at right).
Both devices (VCM 200 EU and VCM 200 MK)
are now ready for cabling.
Junction Box
Wall
Wall Box
Adapter Plate
Euro Channel
Adapter Plate
Trim Plate
Trim
VOLUME
MUTE
VCM 200 MK
VOLUME
MUTE
VCM 200 EU
VOLUME
MUTE
VCM 200 MK
VCM 200 EU and VCM 200 MK • Setup Guide (Continued)
Cabling
Press the VCM 200 into the trim plate and
connect the cables to the rear of the device.
Wire as shown.
A = Pin 1 = 10 VDC reference voltage.
B = Pin 2 = volume and mute control with
DC voltage. The range is 0 to 10 V, where
123
10V
VOL/MUTE
Source
Rear Panel
Black
Ground
0 V is mute and 10 V is maximum volume.
C = Pin 3 is ground.
To complete installation, snap the device and trim plate combination into the secured
adapter plate, taking care not to trap any cables.
Operation
The Mute button toggles between mute and unmute, lights bright red to indicate
mute, and dim white to indicate unmute.
Turn the knob clockwise to increase the volume, and counterclockwise to decrease
the volume.
Audio Level Setting Procedure
To set the system level to not exceed the maximum volume:
1. Reduce the power amplifier volume to minimum.
2. Turn the Volume knob clockwise on the VCM 200 to the maximum position.
3. Slowly turn up the power amplifier to the system volume desired.
Extron
MPA 401
Mini Power
Amplier
SI 3CT LP
Full-Range
Ceiling Speakers
A B C
VCM
Rear Panel
Extron USA - West
Headquarters
+800.633.9876
Inside USA and
Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Right
Left
Extron
MIX 301
Three Channel
Mixer
Wireless
Microphone System
MIX 301
3 CHANNEL
MIXER
MAX
12V
0.5a
IN 1 IN 3
IN 2 MIX OUT
MPA 401-70V
CLASS 2 WIRING
OUTPUT
DO NOT GROUND
OR SHORT
US
®
SPEAKER OUTPUTS!
10V 50mA
LISTED
VOL/MUTE
17TT
70V
AUDIO/VIDEO
APPARATUS
INPUTS
(MONO)
REMOTE
R
L
(MONO)
L
POWER
R
12V
1.5A MAX
Extron
VCM 200 EU
Volume and Mute
VOLUME
Controller
MUTE
Example of a Typical VCM 200 EU Application
Extron USA - East
+800.633.9876
Inside USA and
Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
© 2011 Extron Electronics All rights reserved. www.extron.com
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
68-2089-02
Rev. A
09 11