Extron Electronics Universal Crimp Tool Die User Manual
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
800.633.9876 714.491.1500
FAX 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort, The Netherlands
+800.3987.6673 +31.33.453.4040
FAX +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Rd. #04-01
PM Industrial Bldg., Singapore 368363
+800.7339.8766 +65.6383.4400
FAX +65.6383.4664
Extron Electronics, Japan
Kyodo Building, 16 Ichibancho
Chiyoda-ku, Tokyo 102-0082
Japan
+81.3.3511.7655 FAX +81.3.3511.7656
www.extron.com
Universal Crimp Tool Die
Remove Two
Screws
Bottom
Die
Insert into tool.
Front
Top
Die
Installation Instructions
The Extron Universal Crimp Tool dies can be easily installed or replaced into an
Extron crimp tool handle as follows:
1. Remove the top and bottom screws that hold the existing
dies in the crimp tool.
2. Slide the top and bottom dies out of the crimp tool.
3. Slide the replacement dies into the crimp tool.
N
Pay careful attention to the orientation of the
dies. See the drawing below at right.
4. Use the screws removed in step 1 to secure the
dies in place.
68-1491-01
Rev. A
10 07
Loading...