
Specifications — System 4LD
Video
Gain ............................................... Unity
Bandwidth .................................... 300 MHz (-3dB)
Crosstalk ....................................... -80dB @ 3.58 MHz
Switching speed ........................... 5 mS (max.)
Video input
Number/signal type ................... 4 universal inputs (RGBHV, RGBS, RGsB, RsGsBs, S-video, composite video)
Connectors .................................... 4 x 5 BNC female
Minimum/maximum levels ...... Analog ....... 0.3V to 2V p-p with no offset
Impedance .................................... 75 ohms (deselected inputs)
Horizontal frequency .................. 15 kHz to 150 kHz
Vertical frequency ....................... 30 Hz to 150 Hz
Return loss .................................... -30dB @ 5 MHz
Video output
Number/signal type ................... 1 RGBHV, RGBS, RGsB, line-doubled video
Connectors .................................... 5 BNC female
Minimum/maximum levels ...... 0.3V to 2.0V p-p
Impedance .................................... 75 ohms
Return loss .................................... -25dB @ 10 MHz
DC offset ....................................... ±5mV maximum with input at 0 offset
Switching type ............................. Triple Action, 0 S to 5 S, adjustable
xixi
xi Switcher
xixi
Sync
Input type ..................................... RGBHV, RGBS, RGsB, RsGsBs
Output type .................................. RGBHV, RGBS, RGsB, RsGsBs
Standards ...................................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level ..................................... 0.5V to 5V p-p
Output level.................................. 0.5V to 5V p-p
Input impedance.......................... 510 ohms (deselected inputs)
Output impedance ...................... 75 ohms
Max input voltage ....................... 5V p-p
Max. propagation delay.............. 5 nS
Max. rise/fall time ....................... 5 nS
Polarity .......................................... Positive or negative (follows input)
Audio
Frequency response ..................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................ 0.002% @ 1 kHz at rated maximum output drive
S/N ................................................ >95dB at rated maximum output drive
Crosstalk ....................................... <-85dB @ 20 Hz to 20 kHz, fully loaded
Stereo channel separation .......... >60dB @ 20 Hz to 20 kHz
CMRR ............................................ >60dB @ 20 Hz to 20 kHz
Audio input
Number/signal type ................... 4 stereo, balanced/unbalanced
Connectors .................................... 4 5 mm captive screw connectors, 6 pole
Impedance .................................... >10 kohms unbalanced, >20 kohms balanced, AC coupled
Maximum level ............................ +11.2dBu, (balanced or unbalanced) at stated %THD+N
Input gain adjustment................. –95.5dB to +31.5dB, adjustable per input
1-2 System 4LD
xixi
xi • Specifications
xixi

Audio output
Number/signal type ................... 1 stereo, balanced/unbalanced
Connectors .................................... 1 5 mm captive screw connector, 6 pole
Impedance .................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ...................................... ±0.2dB channel to channel
Maximum level (Hi-Z) ................ >+17.2dBu, balanced or unbalanced at stated %THD+N
Maximum level (600 ohm) ......... >+17.2dBm, balanced or unbalanced at stated %THD+N
0dBu = 0.775 volts (RMS).
Control/remote — switcher
Serial control port ........................ RS-232, 9-pin female D connector
Baud rate and protocol ............... 9600, 8-bit, 1 stop bit, no parity
Serial control pin configurations .... 2 = TX, 3 = RX, 5 = GND
Program control ........................... Extron’s control program for Windows®
Extron’s Simple Instruction Set™ – SIS™
Extron’s Advanced Instruction Set™ – AIS™
Control — projector
Projector control port .................. 1 15-pin HD female connector
General
Power............................................. 100VAC to 240VAC, 50/60 Hz, 20 watts, internal, auto-switchable
Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, non-condensing
Operating +32° to +122°F (0° to +50°C) / 10% to 90%, non-condensing
Rack mount ................................... Yes, with attached rack ears
Enclosure type .............................. Metal
Enclosure dimensions ................. 1.75" H x 17.5" W x 16.3" D (1U high, full rack width)
4.4 cm H x 44.4 cm W x 41.4 cm D
(Depth excludes connectors. Width excludes rack ears.)
Product weight ............................. 10.8 lbs (4.9 kg)
Shipping weight ........................... 17 lbs (7.7 kg)
DIM weight .............. 21
Vibration ....................................... ISTA/NSTA 1A in carton (International Safe Transit Association)
Listings .......................................... UL, CUL
Certifications ................................ CE
MTBF ............................................. 30,000 hours
Warranty ....................................... 3 years parts and labor
Specifications are subject to change without notice.
(7.31-110201-D1)
xixi
xi • Specifications
xixi
1-3System 4LD