SW MTP T 15HD A Series
M TP - M i ni T w i s Te d Pa i r s e r i e s
sPeciFicATions
Vid eo
Number / Signal type . .. .. . .. .. . 1 set of proprietary analog signals
Connectors . .. .. . .. .. . .. .. . .. .. .. . 1 female RJ-45
Vid eo in PuT
Number / Signal type . .. .. . .. .. . 2, 4, or 6 (depending on the model) analog VGA-UXGA RGBHV, RGBS, RGsB,
component video, S-Video or composite video
Connectors . .. .. . .. .. . .. .. . .. .. .. . 2, 4, or 6 (depending on the model) female 15-pin HD
Nominal level . .. . .. .. . .. .. . .. .. . . 1 Vp-p for Y of component video and S-video, and for composite video
0.7V p-p for RGB and for R-Y and B-Y of component video
0.3V p-p for C of S-video
Minimum / Maximum levels .. . Analog: 0.3 V to 1 Vp-p with no offset
Impedance .. .. . .. .. . .. .. . .. .. . .. .. 75 ohms
Horizontal frequency.. . .. .. . .. .. 15 kHz to 130 kHz
Vertical frequency .. . .. .. .. . .. .. . 30 Hz to 150 Hz
Return loss . .. .. . .. .. . .. .. . .. .. . .. <-30 dB @ 5 MHz
DC offset (max. allowable) .. .. .. . 2 V
Vid eo ou TPu T REF ER TO TWI STED PAI R REC EIVE RS’ SPEC IFICAT IONS AND MANU ALS
syn c
Input type .. .. . .. .. .. . .. .. . .. .. . .. . RGBHV, RGBS, RGsB
Standards .. . .. .. . .. .. . .. .. .. . .. .. . NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level . .. . .. .. . .. .. . .. .. . .. .. . 2.5 V to 5.5 V
Input impedance . .. . .. .. . .. .. . .. 560 ohms
Max input voltage .. . .. .. .. . .. .. . 5.5 V
Aud io
Number / Signal type . .. .. . .. .. . 1 set of proprietary analog signals
Connectors . .. .. . .. .. . .. .. . .. .. .. . 1 female RJ-45
Gain .. .. . .. .. .. . .. .. . .. .. . .. .. . .. .. . 0 dB (unbalanced), +6 dB (balanced)
Frequency response .. .. . .. .. . .. 20 Hz to 20 kHz, ±1 dB
THD + Noise .. . .. .. . .. .. . .. .. . .. .. 0.01% @ 1 kHz, 0.03% @ 20 kHz
S/N .. .. . .. .. . .. .. .. . .. .. . .. .. . .. .. . . >75 dB at maximum output, unweighted
Crosstalk . .. .. .. . .. .. . .. .. . .. .. . .. . <-70 dB,@ 20 Hz to 20 kHz, +4 dBu stereo output
Stereo channel separation . .. . >62 dB @ 20 Hz to 20 kHz
CMRR .. .. .. . .. .. . .. .. . .. .. . .. .. . .. . >43 dB @ 20 Hz to 20 kHz
Aud io in PuT
Number / Signal type . .. .. . .. .. . 2, 4, or 6 (depending on the model) stereo, unbalanced
Connectors . .. .. . .. .. . .. .. . .. .. .. . 2, 4, or 6 (depending on the model) 3.5 mm mini audio jacks (tip, ring, sleeve)
Impedance .. .. . .. .. . .. .. . .. .. . .. .. >10k ohms unbalanced
Nominal level . .. . .. .. . .. .. . .. .. . . -10 dBV (316 mVrms)
Maximum level . .. . .. .. .. . .. .. . .. +15 dBV, unbalanced, at <1% THD+N
NOTE: 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Aud io ou TPu T
Number / Signal type . .. .. . .. .. . 1 set of proprietary analog signals to be sent to an MTP receiver
1 stereo, balanced/unbalanced
Connectors . .. .. . .. .. . .. .. . .. .. .. . 1 female RJ-45 (for proprietary signals)
(1) 3.5 mm captive screw connector, 5 pole
Impedance .. .. . .. .. . .. .. . .. .. . .. .. 50 ohms unbalanced, 100 ohms balanced (for the stereo output)
Gain error .. .. . .. .. . .. .. . .. .. .. . .. . ±1 dB channel to channel (for stereo output)
Maximum level (Hi-Z) .. . .. .. . .. . >+23 dBu, balanced, at <1% THD+N (for stereo output)
Maximum level (600 ohm) . .. . . >+17 dBu, balanced at <1% THD+N (for stereo output)
Stereo channel separation . .. . >60 dB @ 1 kHz
con Tro l / r eMo Te — sw iTc he r / Tr Ans Mi TTe r
Serial control port . .. .. . .. .. . .. .. RS-232, 9-pin female D connector (shared with contact closure)
Baud rate and protocol .. . .. .. . . 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin
configurations . .. . .. .. . .. .. . .. .. . 2 = TX, 3 = RX, 5 = GND
Contact closure . .. .. . .. .. . .. .. . .. RS-232, 9-pin female D connector (shared with serial control)
Contact closure pin
configurations . .. . .. .. . .. .. . .. .. . 1 = input 1, 4 = input 2, 5 = GND, 6 = input 3, 7 = input 4, 8 = input 5,
9 = input 6
Program control . .. .. .. . .. .. . .. .. Extron’s control/configuration program for Windows®
Extron’s Simple Instruction Set (SIS™)
Gen erA l
Power .. .. . .. .. . .. .. . .. .. .. . .. .. . .. . Supplied by an external power supply
NOTE: The SW MTP Series transmitters cannot supply remote power to or receive remote power from attached receivers.
External power supply . .. . .. .. . 100 VAC to 240 VAC, 50/60 Hz, external, to 12 VDC, 2 A, regulated
Power input requirements .. . .. 12 VDC, 0.6 A
Temperature / Humidity .. .. . .. . Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, noncondensing
Operating +32° to +122°F (0° to +50°C) / 10% to 90%, noncondensing
Cooling .. . .. .. . .. .. . .. .. . .. .. . .. .. . Convection, unvented
Rack mount . .. . .. .. . .. .. . .. .. . .. . Yes, with optional 1U, 9.5” deep rack shelf, part #60-190-01 or 60-604-01; or
VersaTools® 3” deep rack shelf, part #60-190-20 or 60-604-20.
Also furniture
Enclosure type .. .. .. . .. .. . .. .. . .. Metal
Enclosure dimensions . .. .. . .. .. 1.75" H x 8.75" W x 3.0" D (1U high, half rack wide)
4.4 cm H x 22.2 cm W x 7.6 cm D
(Depth excludes connectors and toggle switch.)
Product weight . .. . .. .. . .. .. . .. .. 0.8 lbs (0.4 kg)
Shipping weight .. . .. .. . .. .. .. . .. 3 lbs (2 kg)
Vibration . .. .. . .. .. . .. .. . .. .. . .. .. . ISTA 1A in carton (International Safe Transit Association)
Listings .. . .. .. . .. .. . .. .. . .. .. . .. .. . UL, CUL
Compliances . .. .. . .. .. . .. .. . .. .. . CE, FCC Class A, VCCI, AS/NZS, ICES
MTBF . .. .. . .. .. . .. .. . .. .. . .. .. . .. .. 30,000 hours
Warranty .. . .. .. . .. .. .. . .. .. . .. .. . . 3 years parts and labor
NOTE: All nominal levels are at ±10%. Specifications are subject to change without notice.
94