Extron Electronics MLA-Remote User Manual
MLA-Remote Remote Control Instruction Guide
MLA-Remote Remote Control Instruction Guide
Install two AAA batteries as shown at right.
Operation
The buttons on the Extron MLA-Remote duplicate the MediaLink™
Controller‘s (MLC’s) front panel controls and also those of an IRCM-VCR and an IRCM-DVD for
normal operation. The MLA-Remote can also be used to control a MediaLink Switcher (MLS).
The controller, control module, or switcher responds to commands from the MLA-Remote as if
the corresponding button or knob were pressed or turned on the controller or switcher.
From a distance of no more than 30 feet and within 40° of the axis (see the illustration on the
other side of this card), the MLA-Remote sends infrared (IR) signals to
• a MediaLink Controller via the controller’s front panel IR pickup device or the IR pickup
device of an optional IR Link IR signal repeater.
• a MediaLink Switcher via a connected IR Link. The switcher can receive signals from the
MLA-Remote only via an IR Link.
Setup operations cannot be performed from the MLA-Remote.
The Display Power button and the VCR and DVD control buttons will not function until
commands have been stored in the MLC 206’s memory. The MLA-Remote’s VCR buttons
control the first (lowest address numbered) IRCM-VCR connected to the MLC. The DVD
buttons control the first (lowest address numbered) IRCM-DVD connected to the MLC.
Commands are transmitted from the MLC 206’s Display/Source Control RS-232 port (via hard
wiring) and IR ports (via IR Emitter or optional IR Broadcaster) when the corresponding button is
pressed on the MLA-Remote or on the controller’s or control module’s front panel. Refer to the
MediaLink Controllers User’s Manual and the Control Modules User’s Manual.
MLA-Remote Remote Control Instruction Guide
Install two AAA batteries as shown at right.
Operation
The buttons on the Extron MLA-Remote duplicate the MediaLink™
Controller‘s (MLC’s) front panel controls and also those of an IRCM-VCR and an IRCM-DVD for
normal operation. The MLA-Remote can also be used to control a MediaLink Switcher (MLS).
The controller, control module, or switcher responds to commands from the MLA-Remote as if
the corresponding button or knob were pressed or turned on the controller or switcher.
From a distance of no more than 30 feet and within 40° of the axis (see the illustration on the
other side of this card), the MLA-Remote sends infrared (IR) signals to
• a MediaLink Controller via the controller’s front panel IR pickup device or the IR pickup
device of an optional IR Link IR signal repeater.
• a MediaLink Switcher via a connected IR Link. The switcher can receive signals from the
MLA-Remote only via an IR Link.
Setup operations cannot be performed from the MLA-Remote.
The Display Power button and the VCR and DVD control buttons will not function until
commands have been stored in the MLC 206’s memory. The MLA-Remote’s VCR buttons
control the first (lowest address numbered) IRCM-VCR connected to the MLC. The DVD
buttons control the first (lowest address numbered) IRCM-DVD connected to the MLC.
Commands are transmitted from the MLC 206’s Display/Source Control RS-232 port (via hard
wiring) and IR ports (via IR Emitter or optional IR Broadcaster) when the corresponding button is
pressed on the MLA-Remote or on the controller’s or control module’s front panel. Refer to the
MediaLink Controllers User’s Manual and the Control Modules User’s Manual.
MLA-Remote Remote Control Instruction Guide
Install two AAA batteries as shown at right.
Operation
The buttons on the Extron MLA-Remote duplicate the MediaLink™
Controller‘s (MLC’s) front panel controls and also those of an IRCM-VCR and an IRCM-DVD for
normal operation. The MLA-Remote can also be used to control a MediaLink Switcher (MLS).
The controller, control module, or switcher responds to commands from the MLA-Remote as if
the corresponding button or knob were pressed or turned on the controller or switcher.
From a distance of no more than 30 feet and within 40° of the axis (see the illustration on the
other side of this card), the MLA-Remote sends infrared (IR) signals to
• a MediaLink Controller via the controller’s front panel IR pickup device or the IR pickup
device of an optional IR Link IR signal repeater.
• a MediaLink Switcher via a connected IR Link. The switcher can receive signals from the
MLA-Remote only via an IR Link.
Setup operations cannot be performed from the MLA-Remote.
The Display Power button and the VCR and DVD control buttons will not function until
commands have been stored in the MLC 206’s memory. The MLA-Remote’s VCR buttons
control the first (lowest address numbered) IRCM-VCR connected to the MLC. The DVD
buttons control the first (lowest address numbered) IRCM-DVD connected to the MLC.
Commands are transmitted from the MLC 206’s Display/Source Control RS-232 port (via hard
wiring) and IR ports (via IR Emitter or optional IR Broadcaster) when the corresponding button is
pressed on the MLA-Remote or on the controller’s or control module’s front panel. Refer to the
MediaLink Controllers User’s Manual and the Control Modules User’s Manual.
Install two AAA batteries as shown at right.
Operation
The buttons on the Extron MLA-Remote duplicate the MediaLink™
Controller‘s (MLC’s) front panel controls and also those of an IRCM-VCR and an IRCM-DVD for
normal operation. The MLA-Remote can also be used to control a MediaLink Switcher (MLS).
The controller, control module, or switcher responds to commands from the MLA-Remote as if
the corresponding button or knob were pressed or turned on the controller or switcher.
From a distance of no more than 30 feet and within 40° of the axis (see the illustration on the
other side of this card), the MLA-Remote sends infrared (IR) signals to
• a MediaLink Controller via the controller’s front panel IR pickup device or the IR pickup
device of an optional IR Link IR signal repeater.
• a MediaLink Switcher via a connected IR Link. The switcher can receive signals from the
MLA-Remote only via an IR Link.
Setup operations cannot be performed from the MLA-Remote.
The Display Power button and the VCR and DVD control buttons will not function until
commands have been stored in the MLC 206’s memory. The MLA-Remote’s VCR buttons
control the first (lowest address numbered) IRCM-VCR connected to the MLC. The DVD
buttons control the first (lowest address numbered) IRCM-DVD connected to the MLC.
Commands are transmitted from the MLC 206’s Display/Source Control RS-232 port (via hard
wiring) and IR ports (via IR Emitter or optional IR Broadcaster) when the corresponding button is
pressed on the MLA-Remote or on the controller’s or control module’s front panel. Refer to the
MediaLink Controllers User’s Manual and the Control Modules User’s Manual.
MLA-Remote Remote Control Instruction Guide, cont’d
100-240V 0.2A 50/60 Hz
INPUT 1
INPUT 2 INPUT 3 INPUT 4 INPUT 5 INPUT 6
LR LR LR LR LR LR
.5A MAX
MLS 306 Rear Panel
R
BGH
V
Y/C
RGBHV
AUDIO OUT
FIXED VARIABLE
OUTPUTS
LRLR
VID
MLC/IR
ABC
RS232
CONTACT CLOSURE
Extron
DISPLAY
POWER
VOLUME
MAX/
MIN
VCR DVD Laptop
MLC 206
MediaLink Controller
MLA-Remote Remote Control Instruction Guide, cont’d
100-240V 0.2A 50/60 Hz
INPUT 1
INPUT 2 INPUT 3 INPUT 4 INPUT 5 INPUT 6
LR LR LR LR LR LR
.5A MAX
MLS 306 Rear Panel
MLC 206
R
BGH
V
Y/C
RGBHV
AUDIO OUT
FIXED VARIABLE
OUTPUTS
LRLR
VID
MLC/IR
ABC
RS232
CONTACT CLOSURE
Extron
DISPLAY
POWER
VOLUME
MAX/
MIN
VCR DVD Laptop
MediaLink Controller
MLC 206
MLC 206
DVD
MLA-Remote
SIGNAL
IR LINK
IR Link
40 40
30 feet
max.
When used to control an MLS switcher, the
DVD
MLA-Remote can be used for input selection
and audio control.
When the MLA-Remote is used to control an
MLC 206, the VCR and DVD buttons can be
used to control only an installed IRCM-VCR
DVD
and an IRCM-DVD. It will not control other
www.extron.com
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
IRCM models.
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
MLA-Remote
68-558-01, Rev. C
Printed in the USA.
MLA-Remote Remote Control Instruction Guide, cont’d
100-240V 0.2A 50/60 Hz
INPUT 1
INPUT 2 INPUT 3 INPUT 4 INPUT 5 INPUT 6
LR LR LR LR LR LR
.5A MAX
MLS 306 Rear Panel
R
BGH
V
Y/C
RGBHV
AUDIO OUT
FIXED VARIABLE
OUTPUTS
LRLR
VID
MLC/IR
ABC
RS232
CONTACT CLOSURE
Extron
DISPLAY
POWER
VOLUME
MAX/
MIN
VCR DVD Laptop
10 02
MLC 206
MediaLink Controller
MLC 206
DVD
MLA-Remote
SIGNAL
IR LINK
IR Link
40 40
30 feet
max.
When used to control an MLS switcher, the
DVD
MLA-Remote can be used for input selection
and audio control.
When the MLA-Remote is used to control an
MLC 206, the VCR and DVD buttons can be
used to control only an installed IRCM-VCR
DVD
and an IRCM-DVD. It will not control other
www.extron.com
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
IRCM models.
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
MLA-Remote
68-558-01, Rev. C
Printed in the USA.
MLA-Remote Remote Control Instruction Guide, cont’d
100-240V 0.2A 50/60 Hz
INPUT 1
INPUT 2 INPUT 3 INPUT 4 INPUT 5 INPUT 6
LR LR LR LR LR LR
.5A MAX
MLS 306 Rear Panel
R
BGH
V
Y/C
RGBHV
AUDIO OUT
FIXED VARIABLE
OUTPUTS
LRLR
VID
MLC/IR
ABC
RS232
CONTACT CLOSURE
Extron
DISPLAY
POWER
VOLUME
MAX/
MIN
VCR DVD Laptop
10 02
MLC 206
MediaLink Controller
MLC 206
www.extron.com
DVD
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
DVD
MLA-Remote
SIGNAL
IR LINK
IR Link
When used to control an MLS switcher, the
MLA-Remote can be used for input selection
and audio control.
When the MLA-Remote is used to control an
MLC 206, the VCR and DVD buttons can be
used to control only an installed IRCM-VCR
and an IRCM-DVD. It will not control other
IRCM models.
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
40 40
30 feet
max.
DVD
MLA-Remote
Printed in the USA.
68-558-01, Rev. C
10 02
www.extron.com
DVD
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
DVD
MLA-Remote
SIGNAL
IR LINK
IR Link
When used to control an MLS switcher, the
MLA-Remote can be used for input selection
and audio control.
When the MLA-Remote is used to control an
MLC 206, the VCR and DVD buttons can be
used to control only an installed IRCM-VCR
and an IRCM-DVD. It will not control other
IRCM models.
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
40 40
30 feet
max.
DVD
MLA-Remote
Printed in the USA.
68-558-01, Rev. C
10 02
Loading...