Extron Electronics MD Floor User Manual

User’s Guide

12. Place the lid on the floor box and slide it away from the
hinge to engage the tabs on the box.

13. Reinstall the two previously removed screws, securing the
lid to the box.

13. Replace screws

12. Slide

14. Reconnect power and cables, as necessary.

Optional Extron Architectural Adapter Plates

A variety of optional architectural adapter plates for pass-through
connections may be ordered for the MD floor box AAP bracket.

The AAP bracket can have up to two architectural adapter plates
installed, depending on the configuration selected.

The following configurations of architectural adapter plates could
be installed in the MD floor box adapter plate:

• two single spaced AAPs

• one double spaced AAP

Extron Electronics, USA

1230 South Lewis Street
Anaheim, CA 92805
USA

www.extron.com

714.491.1500
Fax [phone]

Extron Electronics, Europe

Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax [phone]

© 2002 Extron Electronics. All rights reserved.

Extron Electronics, Asia

135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax [phone]

Extron Electronics, Japan

Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax [phone]

MD Floor Box AAP Bracket

Installation

MD Floor Box AAP Bracket Kit

68-720-01 Rev. A

Printed in the USA

09 02

Installation

Attach with
M4 screws

Introduction

This guide covers installation of the Extron MD Floor Box AAP
Bracket Kit in a Matsushita Denko (MD) floor box. It shows
removal of the old bracket and installation of the new bracket/AAP
unit.

Installation

CAUTION

1. Turn off and disconnect power from all
equipment connected to the floor box.

2. Remove all cables connected to
the portion of the floor box
that is accessible when
the lid is open (if
applicable).

3. Open the lid and
remove the two screws
securing the lid to the
floor box.

4. Remove the lid from
the floor box by sliding
the lid toward the
hinge to disengage it
from the box, then put the
lid aside.

5. Remove the two screws securing the old adapter plate
bracket to the box.

7. Remove the old adapter plate bracket and adapter plate unit
from the floor box.

8. Attach and secure any single or double Extron AAP (for
example, the double AAP shown below) to the MD AAP
bracket with the 4-40 mounting nuts provided.

Installation and service must be performed by
authorized personnel only.

3. Remove screws

9. Connect cables, if applicable, to the back of the AAP to be
installed.

Slide bracket

4. Slide

If an existing adapter plate or blank plate is installed,
complete steps 5 through 7, otherwise skip to step 8.

10. Place the MD AAP bracket into the floor box (as shown
above), routing any cables through the back of the box.

Remove screws

6. Slide the adapter plate bracket to the center of the box and
disconnect the cables attached to the back side of the
adapter plate.

11. Align the two screw holes in the top of the new AAP bracket
with the holes in the box. Attach the bracket with the two
M4 screws provided.

MD Floor Box AAP Kit • InstallationMD Floor Box AAP Kit • Installation

32