Specifications, Cont’d
Product weight
MDA 5SVA RCA,
MDA 3AV RCA ............... 2.2 lbs (1.0 kg)
MDA 5AV RCA ............... 2.3 lbs (1.0 kg)
Shipping weight .......................... 5 lbs (2.3 kg)
Vibration ....................................... ISTA/NSTA 1A in carton (International
Safe Transit Association)
Listings .......................................... UL, CUL
Compliances ................................. CE, FCC Class A, VCCI, AS/NZS, ICES
MTBF ............................................. 30,000 hours
Warranty ....................................... 3 years parts and labor
Specifications are subject to change without notice.
User’s Guide
FCC Class A Notice
Note: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case the user will be required to correct the interference
at his own expense.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded
cables must be used with the unit to ensure compliance.
www.extron.com
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
© 2002 Extron Electronics. All rights reserved.
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
MDA 5SVA RCA / 5AV RCA / 3AV RCA
Video and Audio Mini Distribution Amplifiers
68-615-01 Rev. B
Printed in the USA
08 02
Installation
Installation
The Extron MDA 5SVA RCA, MDA 3AV RCA, and MDA 5AV
RCA are a family of S-video or composite video and stereo audio
mini distribution amplifiers (MDAs) . The stereo audio input and
output are on RCA connectors. Each MDA also has a passive
loop-through for a local monitor.
• MDA 5SVA RCA — S-video DA with one S-video and stereo
audio input and five S-video and stereo audio outputs.
• MDA 3AV RCA — Composite video DA with one video and
stereo audio input and three video and stereo audio outputs.
• MDA 5AV RCA — Composite video DA with one video and
stereo audio input and five video and stereo audio outputs.
The MDAs are rack mountable and have an internal switching
power supply for worldwide power compatibility.
Rack Installation
The 1U high, half rack width MDAs can be mounted on a
standard Universal 1U Rack Shelf (Extron part #60-190-01) (figure
1). If desired, mount the MDA as follows:
1. If feet were previously installed on the bottom of the MDA,
remove them.
2. Mount the MDA on the rack shelf, using two 4-40 x 3/16”
screws in opposite (diagonal) corners to secure the MDA to
the shelf.
3. Install the blank panel (included with the rack shelf) or
another half-rack unit to the rack shelf.
4. Insert the shelf into the rack, aligning the holes in the shelf
with those of the rack.
5. Secure the shelf to the rack using the supplied machine
screws.
Connections, Controls, and Indicator
See figure 2 on the next page to make the following connections.
S-video (MDA 5SVA RCA)
Input connector — Connect an S-video input to this 4-pin
1
mini DIN connector.
Loop connector — Connect an S-video local monitor or
2
other S-video device to this 4-pin mini DIN connector.
Outputs connectors — Connect up to five S-video devices
3
to these 4-pin mini DIN connectors.
Composite video (MDA 3AV RCA and MDA 5AV RCA)
Input connector — Connect a composite video input to
4
this BNC connector.
Loop connector — Connect a composite video local
5
monitor or other composite video device to this BNC
False front panel
uses 2 front holes.
connector.
Outputs connectors — Connect up to three or five
6
composite video devices to these connectors.
Video connector termination switch (all models)
High Z / 75 Ohm switch — Select 75-ohm termination off
7
or on.
M
D
D
A
IS
T
S
R
IB
E
U
R
T
IO
I
E
N
S
A
M
P
L
IF
IE
R
Use 2 mounting holes on
opposite corners.
Figure 1 — Rack mounting the MDA 3 and MDA 5
Series DAs
2
(2) 4-40 x 3/16" Screws
High Z — Select this position if you are connecting a
terminated device to the Loop connector.
75 Ohm — This position terminates the Input connector
with 75 ohms of impedance. Select this position if you
are not using the Loop connector or if you are connecting
an unterminated device to the Loop connector.
MDA 5SVA RCA / 5AV RCA / 3AV RCA • Connection 3MDA 5SVA RCA / 5AV RCA / 3AV RCA • Installation
Connections
11
1 8
100-240V ~ 50/60Hz
0.2A
LOOP
INPUT
IN
HIGH Z
75 Ohm
2 710
OUTPUTS
1
3
2
5
4
3 9
4 8
100-240V ~ 50/60Hz
0.2A
INPUT
IN
LOOP
5 710
HIGH Z
75 Ohm
OUTPUTS
1
3
2
6 9
4 8
100-240V ~ 50/60Hz
0.2A
IN
LOOP
INPUT
HIGH Z
75 Ohm
5 710
OUTPUTS
1
3
2
5
4
6 9
Figure 2 — MDA 3 and MDA 5 Series front and
rear panels
Audio connections (all models)
Audio Input connectors — Connect an unbalanced stereo
8
audio signal to these L(eft) and R(ight) RCA connectors.
Audio Outputs connectors — Connect up to three
9
(MDA 3AV RCA) or five (MDA 5AV RCA or
MDA 5SVA RCA) stereo audio devices to these L(eft) and
R(ight) RCA connectors.
Front Panel, all MDA Models
MDA SERIES
DISTRIBUTION AMPLIFIER
MDA 5SVA RCA,
Rear Panel
INPUT
L
R
1
2
3
OUTPUTS
MDA 5SVA RCA
4
MDA 3AV RCA,
Rear Panel
INPUT
L
R
1
2
OUTPUTS
MDA 3AV RCA
3
MDA 5AV RCA,
Rear Panel
INPUT
L
R
1
2
3
OUTPUTS
MDA 5AV RCA
4
Power
Power connector— Plug a standard IEC power cord into
10
this connector to connect the MDA to a 100 to 240VAC,
50 Hz or 60 Hz power source.
Power LED — The power LED indicates power is applied.
11
Specifications
Video
5
5
Gain ............................................... Unity
Bandwidth
MDA 5SVA RCA ............. 270 MHz (-3dB)
MDA 3AV RCA, MDA 5AV RCA
435 MHz (-3dB)
Differential phase error .............. 0.05º, 0 to 50 MHz
Differential gain error ................. <0.05%, 0 to 50 MHz
Video input
Number/signal type
MDA 5SVA RCA ............. 1 NTSC/PAL/SECAM S-video
MDA 3AV RCA, MDA 5AV RCA
1 NTSC/PAL/SECAM composite video
Connectors
MDA 5SVA RCA ............. 1 4-pin mini DIN female
MDA 3AV RCA, MDA 5AV RCA
1 BNC female
Nominal level
MDA 5SVA RCA ............. Y: 1.0V p-p (including sync), C: 0.3V p-p
MDA 3AV RCA, MDA 5AV RCA
1.0V p-p (including sync)
Minimum/maximum level
MDA 5SVA RCA ............. Y: 0.4V to 2.0V p-p with no offset
MDA 3AV RCA, MDA 5AV RCA
0.4V to 2.0V p-p with no offset
Impedance .................................... 75 ohms
Return loss .................................... -40dB @ 0 to 10 MHz
Maximum DC offset .................... 5.0V
4
5MDA 5SVA RCA / 5AV RCA / 3AV RCA • SpecificationsMDA 5SVA RCA / 5AV RCA / 3AV RCA • Connections
Specifications, Cont’d
Video output
Number/signal type
MDA 5SVA RCA ............. 6 S-video: 5 buffered for distribution,
1 passive loop-through
MDA 3AV RCA ............... 4 composite video: 3 buffered for
distribution, 1 passive loop-through
MDA 5AV RCA ............... 6 composite video: 5 buffered for
distribution, 1 passive loop-through
Connectors
MDA 5SVA RCA ............. 6 4-pin mini DIN
MDA 3AV RCA ............... 4 BNC female
MDA 5AV RCA ............... 6 BNC female
Nominal level
MDA 5SVA RCA ............. Y: 1.0V p-p (including sync), C: 0.3V p-p
MDA 3AV RCA, MDA 5AV RCA
1.0V p-p (including sync)
Minimum/maximum level ........ 0.4V to 2.0V p-p
Impedance .................................... 75 ohms
Return loss .................................... -30dB @ 5 MHz
DC offset ....................................... ±5mV maximum with input at 0 offset
Sync
Standards ...................................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Audio
Gain ............................................... Unity
Frequency response ..................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................ 0.03% @ 1 kHz at nominal level
S/N ................................................ >90 dB, at rated maximum output drive
Stereo channel separation .......... >80 dB @ 1 kHz; >60 dB @ 20 kHz
CMRR ............................................ >75 dB @ 20 Hz to 20 kHz
Audio output
Number/signal type
MDA 5SVA RCA ............. 5 stereo, unbalanced
MDA 3AV RCA ............... 3 stereo, unbalanced
MDA 5AV RCA ............... 5 stereo, unbalanced
Connectors
MDA 5SVA RCA ............. 10 RCA connectors
MDA 3AV RCA ............... 6 RCA connectors
MDA 5AV RCA ............... 10 RCA connectors
Impedance .................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ...................................... ±0.1dB channel to channel
Nominal level ............................... Compatible with +4dBu (1.23V),
0dBu (0.775V), -10dBV (316mV), and
-20dBV (100mV)
Maximum level (Hi-Z) ................ >+24dBu, unbalanced at 1%THD+N
0dBu = 0.775 volts (RMS). 0dBV = 1.0 volts (RMS)
General
Power ............................................. 100VAC to 240VAC, 50/60 Hz, 20 watts,
internal, autoswitchable
Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) /
10% to 90%, non-condensing
Operating +32° to +122°F (0° to +50°C) /
10% to 90%, non-condensing
Rack mount ................................... Yes, with optional 1U rack shelf, part
#60-190-01
Enclosure type .............................. Metal
Enclosure dimensions ................. 1.6" H x 8.75" W x 9.4" D (1U high, half
rack width)
4.1 cm H x 22.2 cm W x 23.9 cm D
(Depth excludes connectors and knobs.)
Audio input
Number/signal type ................... 1 stereo unbalanced
Connectors .................................... 2 RCA connectors
Impedance .................................... >10 kohms unbalanced, DC coupled
Nominal level ............................... Compatible with +4dBu (1.23V),
0dBu (0.775V), -10dBV (316mV), and
-20dBV (100mV)
Maximum level ............................ +24 dBu (unbalanced) at 1%THD+N
7MDA 5SVA RCA / 5AV RCA / 3AV RCA • SpecificationsMDA 5SVA RCA / 5AV RCA / 3AV RCA • Specifications6
Loading...