Extron electronics MBC Sparc Buffer User Manual

User's Guide
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201 Fax 07131 911203
ce-info@camboard.de
EXTRON ELECTRONICS
1230 South Lewis Street Anaheim, CA 92805 (714) 491-1500 FAX (714) 491-1517
U.S.A.
EXTRON ELECTRONICS, EUROPE
Beeldschermweg 6C 3821 AH Amersfoort +31-33-453-4040 FAX +31-33-453-4050
The Netherlands
EXTRON ELECTRONICS, ASIA
Singapore
79-09 68-074-01 Rev. E3
POWER
MBC Sparc Buffer
P/N 26-283-01
MBC SPARC Buffer Operation and Installation MBC SPARC Buffer Operation and Installation
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201 Fax 07131 911203
ce-info@camboard.de
Circuit Board
(
Inside Plastic Cabinet)
POWER
Internal Jumper P1
Internal jumper P1 is located on the circuit board near (behind) the Power LED. The two possible positions for the jumper are "NEXT/SGI" and "SUN"; the factory setting is SUN. If you are experiencing sync problems, check/change the position of P1.
To check or change jumper P1, do the following:
___ Do not open the plastic case while power is applied.
1. The tip of a flat blade screwdriver may be used in the slots on each side to pry open the plastic case. See the diagram above for the location of jumper P1.
2. After checking/changing P1, reassemble the unit and go to the installation instructions.
Page 1
Extron • MBC SPARC Buffer • User’s Guide
Installation Instructions
1. Power OFF the computer.
2. Connect the Extron MBC Sparc Buffer to the Extron analog interface using the 9 pin D sub connector (2a) and plug the 9 volt DC power plug (2b) into the power jack. Set the Extron interface termination switch (if available) to HIGH Z (un-terminated).
3. Connect the Local Monitor (SUNSPARC, SILICON GRAPHICS, NeXT COLOR, or any other computer that uses the 13W3 connector) to the Local Monitor female input (3) on the MBC Sparc Buffer.
4. Connect the 13W3 Male six foot cable (4) to the CPU (Workstation).
5. Be sure that all cable connector screws are secure.
6. Power ON the computer.
Extron • MBC SPARC Buffer • User’s Guide Page 2
Loading...