Extron Electronics LockIt HDMI Cable User Manual

LockIt® HDMI Cable Lacing Bracket Installation Guide

The Extron
a standard HDMI

To securely fasten an HDMI cable to a device:

1. Plug the HDMI cable into the panel connection.

2. Loosen the HDMI connection mounting screw

3. Place the LockIt lacing bracket on

® LockIt lacing bracket makes it possible to simply and universally secure

® cable to most HDMI devices.

NOTE: The HDMI device must have an HDMI connection

mounting screw for this bracket to be used.

1

from the panel enough to allow the LockIt lacing
bracket to be placed over it. The screw does not
have to be removed.

3

the screw and against the HDMI
connector, then tighten the screw
to secure the bracket.

CAUTION: Do not overtighten the

HDMI connection mounting screw.
The shield it fastens to is very thin
and can easily be stripped.

®

LockIt

HDMI Cable Lacing Bracket Installation Guide, continued

The LockIt HDMI lacing bracket can be used in a number of
different configurations as shown.

2

3

Top Mounted

NOTE: The tie wrap can also be tightened

using pliers or similar tools.

Side Mounted

Stacked

4. Loosely place the included tie wrap
around the HDMI connector and the
LockIt lacing bracket as shown.

5. While holding the connector securely
against the lacing bracket, tighten
the tie wrap, then remove any
excess length.

4

3

5

68-2093-01

Rev C 03 12