Hideaway® HSA 200C Series
sPeCif iCations
vid eo — Hs a 200 Ce
Gain .. .. . .. .. .. . .. .. . .. .. . .. .. . .. .. . Selectable: unity (0.7 V), (0.75 V) 50%, (0.8 V) 100%
Bandwidth .. .. . .. .. . .. .. . .. .. . .. .. 300 MHz (-3 dB)
NOTE: ID bits are terminated on pins 4 and 11.
vid eo in Pu t — Hs a 200 C
Number / Signal type . .. .. . .. .. . 1 VGA–UXGA RGBHV, RGBS, RGsB, RsGsBs
Connectors . .. .. . .. .. . .. .. . .. .. .. . (1) 15-pin HD female
vid eo in Pu t — Hs a 200 Ce
Number / Signal type . .. .. . .. .. . 1 VGA–UXGA RGBHV, RGBS, RGsB, RsGsBs
Connectors . .. .. . .. .. . .. .. . .. .. .. . (1) 15-pin HD female
Nominal level . .. . .. .. . .. .. . .. .. . . 0.7 Vp-p for RGB
Minimum / Maximum levels .. . Analog: 0.3 V to 1.5 Vp-p with no offset at unity gain
Impedance .. .. . .. .. . .. .. . .. .. . .. .. 75 ohms
Horizontal frequency.. . .. .. . .. .. 15 kHz to 135 kHz
Vertical frequency .. . .. .. .. . .. .. . 30 Hz to 170 Hz
vid eo ou tP ut — Hs a 200 C
Number / Signal type . .. .. . .. .. . 1 pass-through VGA–UXGA RGBHV, RGBS, RGsB, RsGsBs
Connectors . .. .. . .. .. . .. .. . .. .. .. . 5 BNC female on pigtails
vid eo ou tP ut — Hs a 200 Ce
Number / Signal type . .. .. . .. .. . 1 VGA–UXGA RGBHV, RGBS, RGsB, RsGsBs
Connectors . .. .. . .. .. . .. .. . .. .. .. . 5 BNC female on pigtails
Nominal level . .. . .. .. . .. .. . .. .. . . 0.7 Vp-p for RGB
Minimum / Maximum levels .. . Analog: 0.3 V to 1.5 Vp-p
Impedance .. .. . .. .. . .. .. . .. .. . .. .. 75 ohms
DC offset .. .. . .. .. . .. .. . .. .. . .. .. . . ±5 mV with input at 0 offset
NOTE: Output resolution may vary depending on whether or not the Extender is attached to the computer at startup,
and also on the type of computer being used.
syn C — Hs a 200 Ce
Input type .. .. . .. .. .. . .. .. . .. .. . .. . RGBHV, RGBS, RGsB, RsGsBs
Output type .. .. .. . .. .. . .. .. . .. .. . . RGBHV, RGBS, RGsB, RsGsBs
Input level . .. . .. .. . .. .. . .. .. . .. .. . 2.0 V to 5.0 Vp-p
Output level . .. . .. .. . .. .. . .. .. . .. . TTL: 5.0 Vp-p, unterminated
Input impedance . .. . .. .. . .. .. . .. 510 ohms
Output impedance . .. . .. .. . .. .. . 75 ohms
Max. propagation delay .. .. . .. . 18.8 ns
Max. Rise / Fall time . .. .. .. . .. .. 4 ns
Polarity .. .. . .. .. . .. .. . .. .. . .. .. . .. . Positive or negative (follows input)
aud io — Hs a 200 Ce
Gain .. .. . .. .. .. . .. .. . .. .. . .. .. . .. .. . Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response .. .. . .. .. . .. 20 Hz to 20 kHz, ±0.5 dB
THD + Noise .. . .. .. . .. .. . .. .. . .. .. 0.025% @ 1 kHz, 0.020% @ 20 kHz at nominal level
S/N .. .. . .. .. . .. .. .. . .. .. . .. .. . .. .. . . >90 dB at rated maximum output (21 dB, balanced)
Stereo channel separation . .. . >75 dB @ 20 Hz to 20 kHz
aud io in Pu t — H sa 20 0C
Number / Signal type . .. .. . .. .. . 1 stereo, unbalanced
Connectors . .. .. . .. .. . .. .. . .. .. .. . (1) 3.5 mm stereo female jack
aud io in Pu t — H sa 20 0Ce
Number / Signal type . .. .. . .. .. . 1 stereo, unbalanced
Connectors . .. .. . .. .. . .. .. . .. .. .. . (1) 3.5 mm stereo female jack
Impedance .. .. . .. .. . .. .. . .. .. . .. .. >10k ohms unbalanced, DC coupled
Nominal level . .. . .. .. . .. .. . .. .. . . -10 dBV (316 mVrms)
Maximum level . .. . .. .. .. . .. .. . .. +6 dBu, (balanced or unbalanced) at 1% THD+N
NOTE: 0 dBu = 0.775 Vrms. 0 dBV = 1 Vrms. 0 dBV ≈ 2 dBu.
aud io ou tP ut — Hsa 2 00C
Number / Signal type . .. .. . .. .. . 1 pass-through stereo, unbalanced
Connectors . .. .. . .. .. . .. .. . .. .. .. . (1) 3.5 mm, direct insertion captive screw connector, 3 pole
aud io ou tP ut — Hsa 2 00C e
Number / Signal type . .. .. . .. .. . 1 stereo, balanced/unbalanced
Connectors . .. .. . .. .. . .. .. . .. .. .. . (1) 3.5 mm direct insertion captive screw connector, 5 pole
Impedance .. .. . .. .. . .. .. . .. .. . .. .. 50 ohms unbalanced, 100 ohms balanced
Nominal level . .. . .. .. . .. .. . .. .. . . Unbalanced output: -10 dBV (316 mVrms)
Balanced output: -2 dBu (632 mVrms)
Maximum level (Hi-Z) .. . .. .. . .. . >+14 dBu, balanced at 1% THD+N
Maximum level (600 ohm) . .. . . >+5.5 dBm, balanced at 1% THD+N
Gen er al
Power (HSA 200CE) .. . .. .. . .. .. .. Supplied by an external power supply
External power supply: 100 VAC to 240 VAC, 50/60 Hz, external,
autoswitchable; to 12 VDC, 0.42 A, regulated
Power input requirements: 12 VDC, 0.2 A
Temperature / Humidity
(
HSA 200CE) .. .. . .. .. . .. .. . .. .. . .. . Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +3° to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Rack mount . .. . .. .. . .. .. . .. .. . .. . No, but furniture mountable
Enclosure type .. .. .. . .. .. . .. .. . .. Metal
Enclosure dimensions
CAUTION: Use the appropriate metal Extron routing template or refer to the surface cutout dimensions here before cutting a
hole in the furniture or other surface. Pay special attention to the direction the unit will face; the unit’s connector access side
is underlined. Extron is not responsible for miscut mounting holes.
USA models
Top plate (outer rim) .. .. . .. .. . .. .. 6.500" diameter (16.51 cm diameter) circle
Surface cutout (inside rim) .. .. . .. 6.000 ±0.0325" diameter (15.24 ±0.083 cm diameter) circle
Top plate (inside tilt plate) .. . .. .. . 4.344" W x 3.000" D (11.03 cm W x 7.62 cm D)
Box (under surface) .. .. . .. .. . .. .. . 4.0" H x 4.6" W (front of unit) x 4.4" D
(10.2 cm H x 11.7 cm W x 11.2 cm D) without clamps
4.0" H x 8.0" W (front of unit) x 4.4" D
(10.2 cm H x 20.3 cm W x 11.2 cm D) with clamps
International models
Top plate (outer rim) .. .. . .. .. . .. .. 8.5" diameter (21.6 cm diameter) circle
Surface cutout (inside rim) .. .. . .. 8.0 ±0.0325" diameter (20.3 ±0.083 cm diameter) circle
Top plate (inside tilt plate) .. . .. .. . 5.9" W x 4.1" D (15.1 cm W x 10.4 cm D)
Box (under surface) .. .. . .. .. . .. .. . 4.0" H x 6.3" W (front of unit) x 5.0" D
(10.2 cm H x 15.9 cm W x 12.7 cm D) without clamps
4.0" H x 10.0" W (front of unit) x 5.0" D
(10.2 cm H x 25.3 cm W x 12.7 cm D) with clamps
Product weight
HSA 200C . .. . .. .. .. . .. .. . .. .. . .. .. 4.0 lbs (1.8 kg)
HSA 200CE .. .. .. . .. .. . .. .. . .. .. . .. 5.0 lbs (2.3 kg)
Shipping weight
HSA 200C . .. . .. .. .. . .. .. . .. .. . .. .. 7 lbs (4 kg)
HSA 200CE .. .. .. . .. .. . .. .. . .. .. . .. 8 lbs (4 kg)
Vibration . .. .. . .. .. . .. .. . .. .. . .. .. . ISTA 1A in carton (International Safe Transit Association)
Listings, certification .. . .. .. . .. . UL, CUL, CSA C/US
Compliances
HSA 200CE .. .. .. . .. .. . .. .. . .. .. . .. CE, FCC Class A, VCCI, AS/NZS, ICES
MTBF . .. .. . .. .. . .. .. . .. .. . .. .. . .. .. 30,000 hours
Warranty .. . .. .. . .. .. .. . .. .. . .. .. . . 3 years parts and labor
NOTE: All nominal levels are at ±10%. Specifications are subject to change without notice.
h id e A w A y
®
s ur fA c e Ac c e s s e n c lo s u r es
oPtional aCCessor ies Model de sCriPtio n PaGe Part #
HSA 200 RJ-11 Cable Kit For HSA - Hideaway® Surface Access Enclosures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . n/a 70-231-01
Flexible Conduit Adapter Kit For HSA 200/222 Installation Kit for Hard Wired Electrical Environments - HSA 200/222 . . . . . . . . . . page 140 70-229-01
Hideaway® HSA 200C Series Accessories
routinG t eMPlates Model des CriPtion PaGe Part #
HSA 200/222 and Cable Cubby 300S/300C
Routing Template: US Template HSA 200/222 US Routing Template . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . n/a 70-237-01
HSA 200/222 Routing Template HSA 200/222 International Routing Template . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . n/a 70-237-02
143