Extron Electronics HRP 100 User Manual

HRP 100 • Installation Guide

The Extron® HRP 100 is a one unit high, blank panel that fits in a half-rack width
installation.

Extron does not provide rails for the rack system. These must be purchased and
installed separately (see the user guide provided by the supplier). The distance between
the rails must be half the standard rack width
(8.85 inches or 22.48 cm) between the inside
edges of the rails (see the figure to the right).

Follow these instructions to install the half­rack panel.

1. Position the rack panel to cover a gap in

the equipment rack. Align the holes in
the panel with the holes in the rack.

2. Secure the panel to the equipment rack

using the four provided #10-32 screws
with captive washers.

Extron HRP 100

1U Blank panel

8.85"

Extron USA - West ­Headquarters

+800.633.9876
Inside USA/Canada Only

+1.714.491.1500
+1.714.491.1517 FAX

Extron USA - East

+800.633.9876

Inside USA/Canada Only

+1.919.863.1794
+1.919.863.1797 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040
+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400
+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655
+81.3.3511.7656 FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568
+86.21.3760.1566 FAX

© 2011 Extron Electronics. All rights reserved. www.extron.com

Extron Middle East

+971.4.2991800
+971.4.2991880 FAX

68-2147-02

Rev. A

07 11