Extron Electronics DVI 110 Setup Guide

DVI 110 Installation Guide

Extron

The Extron® DVI 110 Signal Regenerator maximizes the
quality of a digital signal. The DVI 110 should be installed
at the beginning of a cable run, near the DVI source. The
cable from the source to the DVI 110 should be no longer
than 15 feet (4.5 m). To install the regenerator:

1. Mount the DVI 110 (optional).

2. Connect a DVI input device to the input connector on the DVI 110 rear panel.

NOTE::

Alternatively, the DVI 110 can be placed in the middle of a signal path to
improve a poor quality signal.

3. Connect a display device to the output connector on the DVI 110 front panel.

4. (Optional) To maximize signal quality, connect an Extron DVI 101 Cable Equalizer to

the output cable, immediately preceding the display device in the cable run. The
cable between the DVI 101 and the display should be no more than 15 feet (4.5 m).

NOTE: For best results when you are using a DVI 101, the total cable length

from the DVI 110 to the display should be 200 feet (61 m) or less.

5. Connect the provided 12 V, LPS, Class 2, 1 A external power supply

to the 2-pole captive screw connector on the DVI 110 rear panel.

POWER

12V

0.4A MAX

68-1974-50

Rev A

11 10

DVI 110 Installation Guide, cont’d

DVI 101

DVI Equalizer

DVI 101

Short DVI Patch Cable

DVI-D OUTPUT

Laptop with
DVI Output

Short DVI Patch Cable
15' (4.5 m) max.

Extron
DVID SL Pro Series
200' (61 m) max.

POWER
12V

0.4A MAX

Status LED

15' (4.5 m) max.

Projector

DVI-D OUTPUT

Extron
DVI 110

DVI Regenerator

Application Diagram Example

Extron Electronics, Anaheim, CA

www.extron.com

DVI-D OUTPUT

The Status LED on the front
panel lights to indicate the
following:

Amber – Unit receiving power
Green – Input signal present