Extron electronics DTP T/R DP 330, DTP T/R DP 230 Setup Manual

specifications bef

oduct to the po

LR

DDAABBII EE CC

FF HHCC GGII

IR Device

vice

OVER DTP

DTP

HDBT

TP Wires

Pins:

DTP T/R DP 330 and DTP T/R DP 230 • Setup Guide

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

pr

This guide provides instructions for an experienced installer to install either the Extron
DTP T/R DP 330 or DTP T/R DP 230 Display Port Extenders and to make all connections.

Installation

For additional mounting details and considerations, see the DTP T/R DP 330 and DTP T/R 230 User Guide at www.extron.com).

Step 1 — Mounting

Turn off or disconnect all equipment power sources and mount the transmitter and receiver as required.

Step 2 — Input and Output Rear Panel Connections

ore connecting the

wer source.

POWER
12V

0.8A MAX

AUDIO

INPUTS

HDBT

DTP

SIG LINK

OUT

OVER TP

RS-232

Tx Rx Tx RxG

POWER

IR

12V

0.8A MAX

SIG LINK

IN

OVER TP

RS-232

Tx Rx Tx RxG

IR

OUTPUTS

AUDIO

Figure 1. DTP T/R DP 330 and DTP T/R DP 230 Rear Panel Features

DisplayPort Input port — Connect a DisplayPort video input to this connector. The transmitters also accept

A

embedded digital audio on this port.

Audio Input port — Connect an audio input device to this 3.5 mm mini jack on the transmitter.

B

Over TP connector — To pass serial and infrared data or control signals on the Over TP RJ-45

C

output, make the following connections via the RS-232 and IR captive screw connectors on the
transmitter and receiver.

Transmitter — Connect the controlling device.

Receiver — Connect the device to be controlled.

TP function switch —

D

RS-232 IR

Rx

Tx

G

Rx

Tx

TxRx

RxTx

RS-232 De

If the receiving device is in the Extron DTP series, set this switch to DTP. The twisted
pair (TP) output consists of HDMI with embedded audio, analog audio, RS-232 and IR,
and remote power. The transmitter and receiver can be powered by one 12 VDC power
supply connected to either unit.

For an HDBaseT-enabled receiving device, set this switch to HDBT. The TP output consists of HDMI with embedded audio plus
RS-232 and IR. The transmitter and receiving device each requires its own 12 VDC power supply.

ATTENTION:

• Position this switch BEFORE connecting the appropriate device to the TP connector. Failure to comply can damage the

endpoint.

• Positionnez le sélecteur AVANT de connecter l’appareil approprié au connecteur TP. Ne pas respecter cette procédure

pourrait endommager le point de connexion.

Gnd

Gnd

Out port and In port— Connect a shielded twisted pair (STP) cable between the Out (RJ-45) port on the

E

transmitter and either the DTP In port or HDBT port on the receiving device.

F

ATTENTION:

• Do not connect this connector to a computer data or telecommunications network.

• Ne connectez pas ces port à des données informatiques ou à un réseau de télécommunications.

NOTE: Extron XTP DTP 24 shielded twisted pair (STP) cable is preferred for best results, but other

G

STP cable is acceptable. Extron recommends that you terminate both cable ends in accordance
with the following, at a minimum: TIA/EIA T 568B and 24 AWG, solid conductor, shielded cable with
400 MHz bandwidth.

Signal LED indicator — Lights when the device is transmitting or receiving a video signal.

Link LED indicator — Lights when a valid link between a DTP or HDBT input and output is established.

DisplayPort Output port — Connect a DisplayPort video display to this connector.

12345678

TIA/EIA T

Pin

Wire color

White-orange

1

Orange

2
3

White-green

4

Blue

5

White-blue
Green

6
7

White-brown

8

Brown

568B

1

DTP T/R DP 330 and DTP T/R DP 230 • Setup Guide (Continued)

Unbalanced Stereo Output Balanced Stereo Output

Do not tin the wires!

Tip

NO GROUND HERE

NO GROUND HERE

Tip

LR

Sleeves

Tip

Ring

Tip

Ring

LR

Connector

Smooth

Wrap

Rear Panelear Pane

l

Front Panel

ront Pan

e

POWER
12V

0.8 A MAX

AA BB

Audio Output connector — Connect an audio device, such as an audio amplier or powered speakers to this 5-pole, 3.5 mm captive

H

screw connector to receive, unamplied, line level analog audio. This audio is in addition to any audio that may be embedded in the
DisplayPort video signal.

See below to wire the connector. Use the supplied tie-wrap to strap the audio cable to the extended tail of the connector.

ATTENTION:

• For unbalanced audio, connect the sleeves to the

ground contact. Do not connect the sleeves to
the negative (-) contacts.

• Pour l’audio asymétrique, connectez les

manchons au contact au sol. Ne PAS connecter
les manchons aux contacts négatifs (–).

Power — Connect the included 12 VDC power supply to either unit,

I

transmitter or receiver, as shown at right. Use the included tie-wrap to strap
the cord to the captive screw connector.

Connect an IEC power cord between the power supply and a 100-240 VAC,
50-60 Hz source.

NOTE: If the TP switch (D) is in DTP, one supply can power both units.

If the switch is in HDBT, each unit requires its own power supply.

Operation

After all connected devices are connected and powered on, the system is
fully operational. If any issues arise, verify that the cables are routed and
connected properly.

Power Indicators

Power (and signal) LED (front panel) —

A

Amber — The unit is receiving power, either locally or remotely (on the TP cable).

Green — The unit is receiving an active digital input, either on the DisplayPort input if a

transmitter, or transmitted on the DTP cable if a receiver.

Power LED (rear panel) —

B

Amber — The unit is receiving power remotely (on the TP cable).

Green — The unit is receiving power locally.

Ridges

AA

SECTION A–A

Power Supply

Output Cord

3

Captive Screw

Tie

5

Extron Headquarters

+800.633.9876 Inside USA/Canada Only

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.850.1000

+1.714.491.1517 FAX [phone] FAX

2

© 2014 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.299.1800

+971.4.299.1880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1800.3070.3777

(Inside India Only)

+91.80.3055.3777

+91.80.3055.3737 FAX

68-2709-50 Rev. A

10 14