Extron Electronics DTP HDMI 301 Setup Guide
l
l
Panel
DTP HDMI 301 • Setup Guide
INPUTS
Pins:
This guide provides quick start instructions for an experienced installer to set up and operate
Extron DTP HDMI 301 digital video extender. The DTP 301 transmitter and receiver pair can
extend an HDCP-compliant HDMI signal up to 330 feet (100 m).
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the Tx and Rx units as required.
DTP HDMI 301 Tx Rear Panel
DTP HDMI 301 Tx Rear Pane
POWER
12V
0.6 A MAX
INPUTS
SIG LINK
AUDIO
OUT
RS-232 IR
TP HDMI 301 Rx Rear Pane
DTP HDMI 301 Rx Rear Panel
POWER
12V
0.6 A MAX
IN
SIG LINK
OUTPUTS
AUDIO
RxTx
7 71 52
DTP OUT
ANALOG AUDIO
4 43
Step 2 — Connections
HDMI Input connector (Tx) — Connect an HDMI cable
a
between this port and the HDMI output port of the digital
RxTx
ANALOG AUDIO
AUDIO
DTP IN
Front Panel
RS-232 IR
video source.
RxTx
Tx/Rx
Pins
RS-232 IR
TP Wires
RxTx
3
RxTx
RxTx
12345678
Connected RS-232
and IR Device Pins
Pin
Wire color
1
White-green
2
Green
3
White-orange
4
Blue
5
White-blue
6
Orange
7
White-brown
8
Brown
Audio input (Tx) — Connect an unbalanced stereo audio
b
source to this 3.5 mm mini stereo jack for an analog audio
input.
RS-232 and IR connectors — To pass serial or infrared data or control signals, such as
c
serial control of a projector, connect the master device to the transmitter and the slave
device to the receiver via the RS-232 and IR captive screw connectors on both units.
DTP and Analog Audio (Output and Input) RJ-45 connectors — Connect one or
d
two TP cables between these RJ-45 female connectors on the transmitter and receiver.
DTP connector (required) — Connect transmitter DTP Out to receiver DTP In.
Ü
This cable carries:
z TMDS (digital) video
z Embedded audio
z Bidirectional RS-232 and IR commands and data
z Remote power
Signal LED — This LED lights when the unit is receiving a TMDS clock signal on the
HDMI input (transmitter) or any valid signal on the DTP In connector (receiver).
Link LED — This LED lights a valid link is established between the units on the DTP
cable.
Analog Audio connector (optional) — Connect transmitter Analog Audio Out to receiver Analog Audio In. This cable
á
carries analog audio only and is not needed for applications that do not require this audio signal.
Terminate all cable ends in accordance with the same standard, either TIA/EIA T 568 A or TIA/EIA T 568 B.
L R
6
DTP HDMI 301 Rx
Transmit pin on connected unit
Receive pin on connected unit
Ground
Transmit pin on connected unit
Receive pin on connected unit
TIA/EIA T
568 A
TIA/EIA T
568 B
Wire color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
CAUTION: Do not connect these devices to a computer data or telecommunications network.
NOTES: • The DTP and Analog Audio ports are in reverse order on the receiver.
• You can check the DTP Out to DTP In cable connection as follows:
1. Plug a cable into the DTP jack on the powered unit.
2. Connect the opposite end of the cable into the DTP jack on the unpowered unit.
If the DTP Link LED and the Power LED on the unpowered unit are lit, the connection is correct.
OUTPUTS
Rear Panel
ear Pane
l
Front Panel
ront Pane
l
POWER
12V
0.6 A MAX
21
AA
DTP HDMI 301 • Setup Guide (Continued)
HDMI Output connector (Rx) — Connect a display with an HDMI input for display of the
e
transmitted direct digital image.
Audio Output connector (Rx) — Connect a balanced or unbalanced stereo or mono
f
audio device to the receiver via the Audio captive screw connector. See the drawing below.
Tip
LR
Ring
Sleeve(s)
Tip
Ring
LR
L R
Do not tin the wires!
Tip
Sleeve(s)
Tip
Unbalanced Stereo Output Balanced Stereo Output
CAUTION: Connect the sleeves to the ground contact. DO NOT connect the sleeves to the negative (-) contacts).
Power connector — Connect an IEC power cord between the included 12 VDC power supply and a 100-240 VAC, 50-60 Hz
g
source. Connect the power supply to either unit as shown at right.
CAUTION: This product is intended to be supplied by a Listed Power Unit
marked “Class 2” or “LPS,” rated 12 VDC, 1.0 A minimum.
Always use a power supply supplied by or specified by Extron.
Smooth
Ridges
Use of an unauthorized power supply voids all regulatory
compliance certification and may cause damage to the supply
and the end product. Unless otherwise stated, the AC/DC
adapters are not suitable for use in air handling spaces or in
wall cavities. The installation must always be in accordance
with the applicable provisions of National Electrical Code
ANSI/NFPA 70, article 75 and the Canadian Electrical Code
part 1, section 16. The power supply shall not be permanently
fixed to a building structure or similar structure.
NOTE: Only one power supply is required. A single power supply
connected to either unit in the pair powers both units. A power
supply is included with each transmitter.
SECTION A–A
Power Supply
Output Cord
AUDIO
Captive
Screw
Connector
Tie Wrap
3"
16 (5 mm) Max.
Operation
After all devices are powered up, the system is fully operational. See the definitions
of the power indications (shown at right), below:
a Power LED (front panel) —
Amber — The unit is receiving power, either locally or remotely (on the DTP cable).
Green — The unit is powered on and is receiving an active HDMI signal, either on
the HDMI input if a transmitter, or transmitted on the DTP cable if a receiver.
b Power LED (rear panel) —
Amber — The unit is receiving power remotely (on the DTP cable).
Green — The unit is receiving power locally.
If any problems are encountered, verify that the cables are routed and connected properly. If your problems persist, call the
Extron S3 Sales and Technical Support Hotline that is closest to you, at the number shown below.
Extron USA - West
Headquarters
+800.633.9876
Inside USA/Canada
Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA/Canada
Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
68-2156-50
Rev A
07 11
2
© 2011 Extron Electronics. All rights reserved. www.extron.com
Loading...