Extron Electronics CC 200 User Manual

CC 200 Cable Retractor Adapter Kit

The CC 200 Bracket Kit, part #70-678-10, allows one
or two Cable Retractors to be installed in the
Cable Cubby® 200 enclosure. The bracket kit
adapts the AAP opening of the enclosure to
allow the installation of a Cable Retraction
System for Cable Cubby Enclosures.

0.33" (8.4 mm)

(x4)

Planning

Before installing the adapter, be certain there is
adequate space under the table for the retractable system with the
attached bracket.

Determine the retractor mounting orientation: horizontal or vertical.

If only one retractor is mounted, use a filler module, part #70-678-08
in place of the second retractor.

If mounting horizontally, the horizontal
bracket kit, part #70-678-00, is required.

13.6" (345.4 mm)

CC 200
Bracket

Horizontal Mounting Clearance

9.0" (228.6 mm)

(76.2 mm)

3.0"

23.3" (591.8 mm)

Vertical Mounting Clearance

CC 200
Bracket

3.0"

(76.2 mm)

NOTE: To prevent objects from impeding

cable retraction, ensure at least
3 inches of clearance from the
exposed cable side of the enclosure.

68-1894-50

Rev. B

06 11

Bracket and Retractor Mounting

WARNING: Disconnect power from the Cable Cubby 200

power module before beginning installation.

1. Using the mounting bolt supplied with the CC 200 kit

(1/4-20 x 3 in), mount the CC 200 bracket to the retractor as
shown on the right. Do not overtighten the bolt.

Once the retractor is mounted to the bracket, the assembly can
be installed into the enclosure.

2. The cable stops and connecters may be too large to fit through

the AAP opening at the same time as the retractor. Pull a short
amount of cable out of the retractor and push it through the
AAP opening before installing the retractor/bracket assembly.

3. Press the bracket and retractor assembly against the bottom

of the enclosure, lining the bracket holes up with the AAP
mounting holes on the enclosure. Fasten from the top using
the supplied four screws.

4. Refer to the Cable Retraction System for Cable Cubby

Enclosures User Guide at www.extron.com for further

retractor mounting instructions.

CC 200
Bracket

3

Mounting Screw
w/Washer (4 plcs)

2

CC 200 Bracket and
Retractor Assembly

Extron USA - West
Headquarters

+800.633.9876

Inside USA and
Canada Only

+1.714.491.1500
+1.714.491.1517 FAX

Extron USA - East

+800.633.9876

Inside USA and
Canada Only

+1.919.863.1794
+1.919.863.1797 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040
+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400
+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655
+81.3.3511.7656 FAX

© 2011 Extron Electronics All rights reserved. www.extron.com

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568
+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800
+971.4.2991880 FAX

1

Mounting Bolt
and Nut