Extron Electronics CableCover User Manual

CableCoverTM Setup Guide

3

Wrap the CableCover over the cables.
Allow all necessary cables to exit
the side and bottom pass-through
openings.

4

1

Determine the height at which to
attach the provided hook-and-loop
tape on the outside of the enclosure.
Wipe that area using the included
alcohol wipe.

2

Attach the tape around the enclosure
at the chosen height.

Secure the
CableCover to
the tape on the
enclosure.

The Extron CableCover bag mounts to most Cable Cubby® enclosures to minimize tangles and
accidental disconnections, and improve cable management. The bag attaches to the enclosure
using hook-and-loop fasteners, as shown in the instructions below.

Determine the height at which to

1

attach the provided hook-and-loop
tape on the outside of the enclosure.
Wipe that area using the included
alcohol wipe.

Attach the tape around the enclosure

2

at the chosen height.

NOTE: Cut the tape as

necessary to leave any
installation holes accessible.

3

Wrap the CableCover over the cables.
Allow all necessary cables to exit
the side and bottom pass-through
openings.

4

Secure the
CableCover to
the tape on the
enclosure.

Adjust the bag at the top as necessary, depending on

5

enclosure size.

Ensure that cables are routed properly inside the bag

6

and that the bag is tted properly to prevent cable
tangling or obstruction.

68-2639-01 Rev. A

Extron Headquarters

+1.800.633.9876 (Inside USA/Canada Only)

Extron Europe

+31.33.453.4040

© 2014 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com

Extron Asia

+65.6383.4400

Extron Japan

+81.3.3511.7655

Extron China

+86.21.3760.1568

Extron Middle East

+971.4.299.1800

Extron Korea

+82.2.3444.1571

Extron India

+91.80.3055.3777

05 14