Extron Electronics AVTRac End Ramp and Cable Pass-Through Kits User Manual

Extron® AVTrac® End Ramp Kit

End Ramps

End transition ramps are already
provided with all AVTrac system kits.

The ramps are now available as a
separate kit (part number 70-714-01)
for situations where only end ramps
are required to complete an existing
AVTrac installation.

Install the AVTrac system as described
in the AVTrac User Guide, which is
available at www.extron.com.

To add the end ramps to the system:

1. Place the end ramps in position abutting the end of

the track.

2. Pre-drill 5/32 inches diameter holes through the ramp.

3. Drill holes 1.5 inches deep into the floor, using the drill bit

provided.

4. Secure the ramps with the masonry screws provided.

5. Cover the ramps with carpet to finish.

© 2010 Extron Electronics. All rights reserved. www.extron.com

68-1795-01 B

10 10

Extron® AVTrac® Cable Pass-Through Kit

The AVTrac Cable Pass-Through kit is a one-piece pass through transitional ramp that abuts a
hollow table leg, desk or lectern. Cables carried by the AVTrac pass through a hole in the furniture
and run on to connect to the appropriate device.

NOTE: The AVTrac Connectivity Box is not required as cables are routed through the metal

Full details about installing the AVTrac system are
provided in the AVTrac User Guide, available at

www.extron.com).

1. Mark where the end ramp abuts the

2. Drill a hole into the furniture. The hole

3. Pre-drill 5/32 inches diameter holes in the

4. Pre-drill holes 1.5 inches deep in the concrete

5. Secure the track to the floor, using the provided masonry screws.

6. Run power and A/V cables from the wall, along the track and through the furniture. Connect

7. Snap the cover track in place and cover the ramps with carpet to finish.

track and directly into the furniture.

furniture.

must be large enough for the cables to
pass through easily, but small enough to be
concealed by the end ramp kit.

track and ramps.

floor, using the drill bit provided.

the cables as required.

Cable

Pass-Through

Ramp

Side Ramp

Hole Drilled in Furniture

Rubber Strip (optional)

Aluminum
Cover Track