Extron Electronics AVTrac Demonstration Kit User Manual

Connectivity Box (1)

Carpet Finish Cover Track (1)

Rubber finish Cover Track (1)

AC Conduit (1)

Side Ramps (2)

End Ramps (2)

Base Track (1)

Pre-cut Carpet Pieces (2)

Setup Guide for AVTrac™ Demonstration Kit

The AVTrac Demonstration Kit shows how the AVTrac system meets customers' application needs. The kit components can be unpacked from the carrying box as shown in the ﬁgures below. To repack the kit, reverse the steps.

The illustrations below show the US version of the AVTrac Demonstration kit. The International and Universal

models are similar in size and packaging, but contain a single AC outlet, which may be connected to double insulated power cable, or ﬂex conduit without wires.

If the box is to be reused, remember to save

the packing foam.

This kit is for demonstration purposes only. The AC power module is not wired to distribute power and must not be connected to an electrical power source.

1. Remove carpet pieces.

Remove top foam and foam

covering side ramps.

Remove side and end ramps.

4. Remove track pieces and

connectivity box with AC conduit.

PRELIMINARY

68-1530-01

Rev. B 02 09

Setup Guide for AVTrac™ Demonstration Kit, cont’d

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714 .491.1500 +1.714 .491.1517 FAX

Extron USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794 +1.919.863.1797 FA X

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040 +31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400 +65.6383.4664 FAX

Extron Japan

+81.3.3511.7655 +81.3.3511.7656 FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568 +86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800 +971.4.2991880 FAX

End Ramps

Cover Track w/ Rubber (shown) or Carpet Finish

Side Ramps

Aluminum Base Track

Connectivity (AAP) Box

Ensure that the kit contains all the items shown in the ﬁgure below and assemble the kit components by following the steps below.

The illustration below shows the US version of the AVTrac Demonstration kit. The International and Universal

models are similar in size and packaging, but contain a single AC outlet, which may be connected to double insulated power cable, or ﬂex conduit without wires.

PRELIMINARY

1. Place aluminum base track on a ﬁrm, ﬂat surface.

2. Attach the side ramps by mating the tabs in the ramps with the grooves in the track.

3. Place the end ramps in position at the end of the track pieces.

4. Place the connectivity box ﬂush with the end of the track nearest the end ramps. The AC conduit should run

Attach the cover track (either rubber or carpet ﬁnish) by snapping it onto the base track.

6. Place the pre-cut carpet pieces on top of the ramps and around the connectivity box.

from the connectivity box to the opposite end of the track.

ww.extron.com