VTT001 and VTR001 • Setup Guide
This guide provides basic instructions for an
experienced installer to set up and operate the
VTT001 and VTR001.
Step 1 — Powering down
Power off and disconnect all devices from
the power source.
Step 2 — Connecting the TP cable
Connect the RJ-45 connectors of the transmitter and
receiver to either end of the TP cable. Terminate the
cables using the same standard as shown to the right.
Step 3 — Connecting input/output devices
Pins:
1234567 8
Insert Twisted
Pair Wires
T568A T568B
Pin
Wire color
1
White-green
2
Green
3
White-orange
Blue Blue
4
White-blue
5
6
Orange
7
White-brown
8
Brown
NOTE:
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
If you are using Enhanced
Skew-Free™ A/V cable, use
theTIA/EIA T568A standard only.
Wire color
Using the 15-pin front panel HD connectors, attach
RGBHV or RGBS input to the transmitter and a display output to
the receiver (see the example application diagram below).
Step 4 — Connecting the power supply
Connect the external power supply to the power input of the transmitter,
or the receiver, or to both, then plug the power supply into the AC power
source and power on the transmitter/receiver modules and the input/output devices.
NOTES:
• Both transmitter and receiver have remote power capability.
• For transmission distances up to 300 feet, the power is required at either the
transmitter or the receiver. Greater distances require power to be applied locally to
both the transmitter and the receiver.
CPM101
Step 5 — Adjusting sharpness
For the VTR001 Series, set the sharpness
control located on top of the receiver.
See the illustration below.
Turning the control
clockwise increases
sharpness and turning it
counterclockwise
decreases sharpness.
Extron USA Headquarters Extron USA - West: +1.714.491.1500 +1.714.491.1517 FAX
+1.800.633.9876 (Inside USA/Canada Only) Extron USA - East: +1.919.863.1794 +1.919.863.1797 FAX
© 2012 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
Sharpness
SHARP
OUTPUT
VTR00 1 MAA P
Mounting Frame
OUTPUT
Extron
Skew-Free™ A/V UTP
Cable
(up to 500')
Extron
VTT001 MAAP
Twisted Pa ir Transmitter
POWER
VTR001 M AA P
Extron
VTR001 MAAP
Twisted Pa ir
Receiver
POWER
VIDEO INPUT
VTT001 M AA P
LCD Projector
Extron
CPM101
Mounting Frame
68-760-50 Rev. B
Laptop
03 12