Extron electronic V-LockTM User Manual

User’s Guide

V-Lock™ Wall Mount Assembly Kit

Replacement accessory for Extron System INTEGRATOR

SI 3 Surface Mount Speakers

68-1490-01

Rev. A

03 08

®

Introduction

Allen Hex Tool

Wall Mount
Assemblies

Outer
Packaging

V Lock
Groove
(Stage)

Hex Lock
Screw

Pivot
Ball

Wall
Plate

Wiring
Access
Hole

Secondary
Mounting
Holes (4)

Primary
Mounting
Holes (2)

Packaging Information

The V-Lock™ Assembly Kit contains two individually packed
wall mount assemblies (one for each speaker) and an Allen hex
tool.

Figure 1 — V-Lock Assembly packaging details

About the V-Lock Assembly Kit

The V-Lock Wall Mount Assembly Kit is a pair of replacement
wall mount assemblies (wall plate and V-lock groove only) for
the Extron System INTEGRATOR® SI 3 surface mount speakers.

1

Figure 2 — Main parts of the V-Lock Assembly Kit

V-Lock™ Wall Mount Assembly Kit • Introduction

Installation

To remove (or insert) the wires,
push down on the spring terminals
at the back of the speaker.
Release the springs to secure.

INPUT

Positive Wire

Negative
Wire

Installing the V-Lock™ Assembly Kit

If your speakers are not already installed, follow the instructions
outlined in the SI 3 User's Guide supplied with the speakers (or
online at www.extron.com).

If your speakers are already installed, replace the V-Lock
assembly by following the instructions, below.

N Referring to packaging information for location,

carefully remove and check contents before installation.

N Extron recommends that the wiring installation is

performed by a professional audio equipment installer.

N For speaker details, specifications, troubleshooting tips,

and service access information, refer to the
SI 3 User's Guide supplied with the speakers, or online
at www.extron.com.

Existing wall mounting application

To replace a damaged V-Lock assembly that is already installed,
do the following:

1. Remove the Extron logo from the front of the speaker to
access the hex cap screw. Retain the logo.

2. Insert the hex tool and unlock the speaker.

3. Carefully lift the speakers away from the bracket, then

disconnect the seismic cable and audio wires from the rear
of the speakers.

Figure 3 — Remove audio wires from the terminals

N

If the ends of the wires are damaged and need to be

re-stripped, follow the instructions in the SI 3 User's

Guide.

V-Lock™ Wall Mount Assembly Kit • Installation

2