Specifications — SW 6 CV/SV/SV A/SA/AV MX Switchers
Video
Gain ............................................... Unity
Bandwidth .................................... 30 MHz (-3dB)
Differential phase error .............. 0.01º, 4.43 to 30 MHz
Differential gain error ................. 0.03%, 4.43 to 30 MHz
Crosstalk ....................................... -70dB @ 3.58 MHz
Switching speed ........................... 160 nS (max.)
Video input
Number/signal type ................... 6 S-video ................................... SW 6 SV MX, SW 6 SV A MX
6 composite video ................... SW 6 CV MX, SW 6 AV MX
Connectors .................................... 6 4-pin mini-DIN female....... SW 6 SV MX, SW 6 SV A MX
6 BNC female .......................... SW 6 CV MX, SW 6 AV MX
Minimum/maximum levels ...... Analog ....... 0.3V to 1.5V p-p with no offset
Impedance .................................... 75 ohms (all inputs are terminated at 75 ohms)
Return loss .................................... -41dB @ 5 MHz
External sync (genlock) ............... 0.3V to 0.4V p-p
Video output
Number/signal type ................... Individually buffered
2 S-video ...................................SW 6 SV MX, SW 6 SV A MX
2 composite video ................... SW 6 CV MX, SW 6 AV MX
Connectors .................................... 2 4-pin mini-DIN female....... SW 6 SV MX, SW 6 SV A MX
2 BNC female .......................... SW 6 CV MX, SW 6 AV MX
Minimum/maximum levels ...... Analog ....... 0.3V to 1.5V p-p
Impedance .................................... 75 ohms
Return loss .................................... -47dB @ 5 MHz
DC offset ....................................... ±5mV maximum with input at 0 offset
Switching type ............................. Vertical interval
Sync
Genlock connectors ..................... 2 BNC female
Standards ...................................... NTSC, PAL, SECAM
Input level ..................................... 0.3V to 5.0V p-p ........ SW 6 SV A MX
0.5 to 5.0V p-p........... all other models
Output level.................................. TTL ............. 4V to 5V p-p
Polarity .......................................... Positive or negative (follows input)
Audio — SW 6 SA MX, SW 6 SV A MX, and SW 6 AV MX only
Gain ............................................... Unbalanced -15dB to +9dB, balanced -9dB to +15dB
Frequency response ..................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................ 0.03% @ 1 kHz, 0.3% @ 20 kHz at rated maximum output drive
S/N ................................................ >90dB at rated maximum output drive
Crosstalk ....................................... <-65dB @ 20 kHz, <-80dB @ 1 kHz or below 60 Hz, fully loaded
Stereo channel separation .......... >80dB @ 20 Hz to 20 kHz
CMRR ............................................ >75dB @ 20 Hz to 20 kHz
Audio input — SW 6 SA MX, SW 6 SV A MX, and SW 6 AV MX only
Number/signal type ................... 6 stereo, balanced/unbalanced
Connectors .................................... 6 3.5 mm captive screw connectors, 5 pole
Impedance
SW 6 SV A MX ................. >10 kohms unbalanced, >20 kohms balanced, DC coupled
SW 6 SA MX, SW 6 AV MX >25 kohms balanced, 50 kohms unbalanced, DC coupled
Maximum level ............................ +15dBu, (balanced or unbalanced) at stated %THD+N
Input gain adjustment................. -15dB to +9dB, adjustable per input
1-2 SW 6 CV MX, SW 6 SV MX, SW 6 SA MX, SW 6 AV MX, SW 6 SV A MX • Specifications
Audio output — SW 6 SA MX, SW 6 SV A MX, and SW 6 AV MX only
Number/signal type ................... 2 stereo, balanced/unbalanced
Connectors .................................... 2 3.5 mm captive screw connnectors, 5 pole
Impedance .................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ...................................... ±0.1dB channel to channel
Maximum level (Hi-Z) ................ >+21dBu, balanced or unbalanced at stated %THD+N
Maximum level (600 ohm) ......... >+15dBm, balanced or unbalanced at stated %THD+N
0dBu = 0.775 volts (RMS).
Control/remote — switcher
Serial control port ........................ RS-232, 9-pin D female connector
Baud rate and protocol ............... 9600, 8-bit, 1 stop bit, no parity
Serial control pin configurations 2 = TX, 3 = RX, 5 = GND
Contact closure ............................ 9-pin D female
Contact closure pin configurations 1 = input 1, 2 = input 2, 5 = GND, 6 = input 3, 7 = input 4, 8 = input 5, 9 = input 6
Program control ........................... Extron’s control program for Windows®
Extron’s Simple Instruction Set
™ – SIS™
General
Power............................................. 100VAC to 240VAC, 50/60 Hz, 10 watts, internal, auto-switchable
Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, non-condensing
Operating +32° to +122°F (0° to +50°C) / 10% to 90%, non-condensing
Rack mount ................................... Yes, with optional 1U rack shelf, part #60-190-01
Enclosure type .............................. Metal
Enclosure dimensions ................. 1.75" H x 8.75" W x 9.5" D (1U high, 1/2 rack width)
4.4 cm H x 22.2 cm W x 24.1 cm D
(Depth excludes connectors.)
Product weight
SW 6 CV MX ..................... 2.9 lbs (1.3 kg)
SW 6 SV MX, SW 6 SA MX 2.7 lbs (1.2 kg)
SW 6 AV MX .................... 3.3 lbs (1.5 kg)
SW 6 SV A MX ................. 3.0 lbs (1.4 kg)
Shipping weight
SW 6 CV MX, SW 6 SV MX, SW 6 SA MX ........... 5 lbs (2.3 kg)
SW 6 AV MX, SW 6 SV A MX ................................ 6 lbs (2.7 kg)
Vibration ....................................... ISTA/NSTA 1A in carton (International Safe Transit Association)
Listings .......................................... UL, CUL
Compliances ................................. CE, FCC Class A
MTBF ............................................. 30,000 hours
Warranty ....................................... 3 years parts and labor
Specifications are subject to change without notice.
(7.31-030702-D1)
1-3SW 6 CV MX, SW 6 SV MX, SW 6 SA MX, SW 6 AV MX, SW 6 SV A MX • Specifications