SPECIFICATIONS (CONT.)
VIDEO
Gain............................................ Unity
Bandwidth .................................. 350 MHz (-3dB), fully loaded
Differential phase error .............. 1.0%, 0 to 350 MHz
Differential gain error.................. 1.0%, 0 to 350 MHz
Crosstalk .................................... -70dB @ 10 MHz
Switching speed ........................ 5 ms (max.)
VIDEO INPUT
Number/signal type
SW2/4/6 ................................ 2, 4, 6 RGBHV, RGBS, RGsB, RsGsBs,
component video, S-video, composite
video
Connectors
SW2 RGBHV/RGBHV A............ 2 x 5 BNC female
SW4 RGBHV/RGBHV A............ 4 x 5 BNC female
SW6 RGBHV/RGBHV A............ 6 x 5 BNC female
Minimum/maximum levels ........ Analog–0.3V to 1.5V p-p with no offset
Impedance.................................. 75 ohms
Return loss .................................. -30dB @ 10 MHz
Maximum DC offset .................. 5.0V
VIDEO OUTPUT
Number/signal type
All models ............................ 1 RGBHV, RGBS, RGsB, RsGsBs,
component video, S-video, composite
video (or digital audio)
Connectors
All models.................................. 5 BNC female
Impedance.................................. 75 ohms
SYNC
Input type .................................. RGBHV (except SW6 YUV A), RGBS,
RGsB, RsGsBs
Output type................................ RGBHV (except SW6 YUV A), RGBS,
RGsB, RsGsBs
Input level .................................. Analog or TTL, 0.5V to 5.0V p-p
Output level................................ 5.0V p-p (if not terminated)
Input impedance ........................ 510 ohms
Output impedance .................... 75 ohms
Max. input voltage .................... 5.0V p-p
Max. propagation delay.............. 35 ns
Max. rise/fall time ...................... 4 ns
Polarity ...................................... Positive or negative (follows input)
AUDIO — SW 2/4/6 RGBHV A ONLY
Gain............................................ Adjustable when audio gain is set to
unity (0dB), balanced output will have
a 0dB gain; unbalanced output will be
attenuated by 6dB.
Frequency response .................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise .............................. 0.03% @ 1 kHz, 0.3% @ 20 kHz at
rated maximum output drive
S/N ............................................ >90dB at rated maximum output drive
Crosstalk .................................... <-65dB @ 20 kHz, <-80dB @ 1 kHz or
below 60 Hz
Stereo channel separation .......... >80dB @ 20 Hz to 20 kHz
CMRR ........................................ >75dB @ 20 Hz to 20 kHz
AUDIO INPUT — SW 2/4/6 RGBHV A ONLY
Number/signal type.................... 2, 4, or 6 stereo, balanced/unbalanced
Connectors ................................ 2, 4, or 6 3.5 mm captive screw
connectors, 5 pole
Impedance.................................. >10 kohms unbalanced, 20 kohms
balanced, DC coupled
Nominal level (configurable) ...... -20dBV (100mV), -10dBV (316mV),
0dBu (0.775V), or +4dBu (1.23V),
Maximum level .......................... +20dBu, (balanced or unbalanced) at
stated %THD+N
Input gain adjustment ................ -18dB to +24dB, adjustable per input
AUDIO OUTPUT — SW 2/4/6 RGBHV A ONLY
Number/signal type.................... 1 stereo, balanced/unbalanced
Connectors ................................ 1 3.5 mm captive screw connector,
5 pole
Impedance.................................. 50 ohms unbalanced, 50 ohms balanced
Nominal level.............................. -20dBV (100mV), -10dBV (316mV), 0dBu
(0.775V), or +4dBu (1.23V), configurable
Maximum level (Hi-Z) ................ >+20dBu, balanced or unbalanced at
stated %THD+N
Maximum level (600 ohm) ........ >+15dBm, balanced or unbalanced at
stated %THD+N
NOTE: 0dBu = 0.775 volts (RMS). 0dBV = 1.0V.
CONTROL/REMOTE — SWITCHER
Serial control port ...................... RS-232, 9-pin female D connector
(same as the contact closure port)
Baud rate and protocol .............. 9600, 8-bit, 1 stop bit, no parity
Serial control
pin configurations .................. 2 = TX, 3 = RX, 5 = GND
Contact closure .......................... 9-pin female D connector (same as the
RS-232 port)
Contact closure
pin configurations .................. 1 = input #1, 4 = input #2,
6 = input #3, 7 = input #4,
8 = input #5, 9 = input #6
Program control.......................... Extron’s control program for Windows
®
Extron’s Simple Instruction Set™– SIS
™
GENERAL
Power ........................................ 100VAC to 240VAC, 50/60 Hz,
20 watts, internal, autoswitchable
Rack mount
SW2 RGBHV,
SW2 RGBHV A ........................ Yes, with optional rack shelf,
part #60-190-01
All other models .................... Yes, with included bracket kit,
part #70-077-03
Enclosure type .......................... Metal
Enclosure dimensions
SW2 RGBHV,
SW2 RGBHV A ........................ 1.75" H x 8.75" W x 9.5" D
(1U high, half rack width) 4.4 cm H x
22.2 cm W x 24.1 cm D
(Depth excludes connectors.)
All other models .................... 1.75" H x 17.5" W x 8.5" D
(1U high, full rack width) 4.4 cm H x
44.5 cm W x 21.6 cm D
(Depth excludes connectors.)
Product weight
SW2 RGBHV, SW2 RGBHV A .. 4.0 lbs (1.8 kg)
All other models .................... 7.0 lbs (3.2 kg)
Shipping weight
SW2 RGBHV, SW2 RGBHV A .. 8 lbs (3.6 kg)
All other models .................... 12 lbs (5.4 kg)
Listings ...................................... UL, CUL
Compliances .............................. CE, FCC Class A, VCCI, AS/NZS, ICES
MTBF.......................................... 30,000 hours
Warranty .................................... 3 years parts and labor
Model Part Number
RGBHV Only Models
SW2 RGBHV .......................... 60-491-01
SW4 RGBHV .......................... 60-492-01
SW6 RGBHV .......................... 60-493-01
RGBHV & Audio Models
SW2 RGBHV A ........................ 60-491-21
SW4 RGBHV A ........................ 60-492-21
SW6 RGBHV A ........................ 60-493-21
IR 102 Kit.................................... 70-224-01
KP 6 Keypad Remote control ...... 60-111-20