Extron electronic RGB 320 User Manual

Specifications — RGB 320 Architectural Series Interface
Video
Routing .......................................... 6 x 1, 2 distributed outputs
Gain ............................................... -0.33V to +0.33V p-p
Peaking .... 0%, 50%, 100% (switch-selectable)
Bandwidth .................................... 220 MHz (-3dB)
Number/signal type ................... 6 analog RGBHV, RGBS, RGsB, RsGsBs
Connectors .................................... 6 x 5 female BNC
Minimum/maximum levels ...... Analog ....... 0.3V to 1.45V p-p with no offset at unity gain
Impedance .................................... 75 ohms
Horizontal frequency .................. 15 kHz to 150 kHz (optimum 15 kHz to 62 kHz)
Vertical frequency ....................... 30 Hz to 170 Hz
Return loss .................................... -30dB @ 5 MHz
Video output
Number/signal type ................... 2 analog RGBHV, RGBS, RGsB
Connectors .................................... 2 x 6 female BNC
Minimum/maximum levels ...... 0.5V to 1.45V p-p
Impedance .................................... 75 ohms
Return loss .................................... -30dB @ 5 MHz
Sync
Input type ..................................... Autodetect RGBHV, RGBS, RGsB, RsGsBs
Output type .................................. RGBHV ...... at all times
RGBS .......... at all times
RGsB .......... switch-selectable
Input level ..................................... 2.0V to 5.5V p-p with ±0.2VDC offset max.
Output level .................................. 4.0V to 5.0V p-p
Input impedance .......................... 10 kohms
Output impedance....................... 75 ohms
Max. propagation delay .............. 88 nS
Max. rise/fall time ....................... 3.2 nS
Polarity .......................................... Positive, negative
Audio
Routing .......................................... 6 x 1, 2 distributed outputs
Gain ............................................... Unbalanced 0dB, balanced +6dB
Frequency response ..................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................ 0.03% @1 kHz, 0.3% @ 20 kHz, +15dBu input, +21dBu output
Balanced input and output
S/N ................................................ >90dB, balanced, at rated maximum output (+21dBu)
Crosstalk ....................................... >65dB @ 20 kHz, >80dB @1 kHz, >80dB below 60 kHz, fully loaded
Stereo channel separation ........... >80dB @1 kHz, >60dB @ 20 kHz
CMRR ............................................ >75dB 20 Hz to 20 kHz
Audio input
1-2
Number/signal type ................... 6 stereo, balanced/unbalanced
Connectors .................................... 6 3.5 mm captive screw connectors, 5 pole
Impedance .................................... >25 kohms balanced, 50 kohms unbalanced, DC coupled
Maximum level ............................ +19.5dBu, balanced or unbalanced
Input gain adjustment ................. –15.0dB to +9.0dB, adjustable per input
RGB 320 Switching Interface • Specifications
Audio output
Number/signal type ................... 2 stereo (2 channel), balanced/unbalanced
Connectors .................................... 2 3.5 mm captive screw connectors, 5 pole
Impedance .................................... Unbalanced 50 ohms, balanced 100 ohms
Gain error ...................................... ±0.1dB channel to channel
Maximum level (Hi-Z) ................ >+21.0dBu, balanced at stated %THD+N
Maximum level (600 ohm) ......... > +15.0dBu, balanced at stated %THD+N
0dBu = 0.775 volts (RMS).
Control/remote — switching interface
Serial control port ........................ RS-232, 9-pin female D connector
Baud rate and protocol ............... 9600, 8-bit, 1 stop bit, no parity
Serial control pin configurations .... 2 = TX, 3 = RX, 5 = GND
Contact closure ............................ 9-pin female D connector
Contact closure pin configurations 1 = input 1, 4 = input 2, 5 = GND, 6 = input 3, 7 = input 4, 8 = input 5, 9 = input 6
Program control ........................... Extron’s control program for Windows®
Extron’s Simple Instruction Set™ – SIS™
General
Power ............................................. 100VAC to 240VAC, 50/60 Hz, 20 watts, internal, auto-switchable
Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, non-condensing
Operating +32° to +122°F (0° to +50°C) / 10% to 90%, non-condensing
Rack mount ................................... Yes
Enclosure type .............................. Metal
Enclosure dimensions ................. 3.5” H x 19.0” W* x 9.5” D
8.89 cm H x 48.26 cm W* x 24.13 cm D
Depth excludes connectors and knobs. *Width includes attached rack ears.)
Shipping weight ........................... 16 lbs (7.2 kg)
DIM weight............... 25
Vibration ....................................... ISTA/NSTA 1A in carton (International Safe Transit Association)
Approvals ..................................... UL, CE, FCC Class A
Warranty ....................................... 2 years parts and labor
Specifications are subject to change without notice.
RGB 320 Switching Interface • Specifications
(7.2-112012-D1)
1-3
Loading...