Extron electronic RGB 202 Rxi VTG, RGB 202 Rxi User Manual

Specifications — RGB 202 Rxi , RGB 202 Rxi VTG

Video

Routing.......................................... 2 x 1 router

Gain ............................................... 0.5V to 1.45V p-p

Bandwidth .................................... 300 MHz (-3dB)

Rise time........................................ 1.5 ns

Video input

Number/signal type ................... 2 analog RGBHV, RGBS, RGsB, RsGsBs

Connectors .................................... (2) 9-pin D male for MBC/LBC cable or buffer

Nominal level ............................... 0.7V p-p for RGB

Minimum/maximum levels ...... Analog: 0.3V to 1.45V p-p with no offset at unity gain

Impedance .................................... 75 ohms or high Z, switchable (set to 75 ohms if no local monitor is connected)

Horizontal frequency .................. 15 kHz to 150 kHz

Vertical frequency ....................... 40 Hz to 140 Hz

Return loss .................................... <-30dB @ 5 MHz

Maximum DC offset .................... 4V

Video signal characteristics — RGB 202 Rxi VTG only

Dot clock ....................................... VGA 25.18 MHz, Mac 30.04 MHz, SVGA 65.04 MHz, SGI 107.4 MHz

Pixel clock accuracy..................... > 99.02%

Scan rate accuracy ....................... > 99.03%

Frequency range .......................... VGA ..... 31.475 kHz x 60 Hz,

SVGA ... 37.879 kHz x 60 Hz,

XGA ..... 48.392 kHz x 60 Hz,

SGI........ 63.928 kHz x 60 Hz

Rise/fall time ............................... 2.5 ns / 2.0 ns, measured

Video output

Number/signal type ................... 1 analog RGBHV, RGBS, RGsB

Connectors .................................... 6 BNC female

Nominal level ............................... 0.7V p-p for RGB

Minimum/maximum levels ...... 0.3V to 1.30V p-p with 0.7V p-p nominal input level

Impedance .................................... 75 ohms

Return loss .................................... -30dB @ 5 MHz

DC offset ....................................... ±5mV maximum with input at 0 offset

Sync

Input type ..................................... RGBHV, RGBS, RGsB, RsGsBs

Output type .................................. RGBHV, RGBS, RGsB

Input level ..................................... 2V to 5.5V p-p with ±0.2VDC offset max.

Output level.................................. TTL: 4V to 5V p-p, unterminated

Input impedance.......................... 510 ohms

Output impedance ...................... 75 ohms

Max. propagation delay.............. 85 ns

Max. rise/fall time ....................... 2 ns

Polarity .......................................... RGBHV...................... tracks polarity (or force negative sync via DIP switch)

RGBS, RGsB .............. negative

Audio

Routing.......................................... 2 x 1 stereo router

Gain ............................................... Unbalanced output: 0dB; balanced output: +6dB

Frequency response ..................... 20 Hz to 20 kHz, ±0.05dB

THD + Noise ................................ 0.03% @ 1 kHz, 0.3% @ 20 kHz at nominal level

S/N ................................................ >90dB at rated maximum output (17dBu), balanced

1-2 RGB 202 Rxi , RGB 202 Rxi VTG • Specifications

Crosstalk ....................................... <-90dB @ 1 kHz, fully loaded

Stereo channel separation .......... >90dB @ 1 kHz to 20 kHz

Audio input

Number/signal type ................... 2 PC level stereo, unbalanced

Connectors .................................... (2) 3.5 mm stereo jacks (female) (2 channel); tip (L), ring (R), sleeve (ground)

Impedance .................................... >10 kohms, unbalanced, DC coupled

Nominal level ............................... -10dBV (316mV)

Maximum level ............................ +8.5dBu, (balanced or unbalanced) at 1%THD+N

Audio output

Number/signal type ................... 1 buffered stereo (2 channel), balanced/unbalanced

Connectors .................................... (1) 3.5 mm, captive screw connector, 5-pole

Impedance .................................... 50 ohms unbalanced, 100 ohms balanced

Gain error ...................................... ±0.1dB channel to channel

Maximum level (Hi-Z) ................ >+14dBu, balanced at stated %THD+N

Maximum level (600 ohm) ......... >+8.5dBm, balanced at stated %THD+N

0dBu = 0.775 volts (RMS).

Control/remote — interface

Serial control port ........................ RS-232, 9-pin female D connector (also used for contact closure)

Baud rate and protocol ............... 9600, 8-bit, 1 stop bit, no parity

Serial control pin configuration .. 2 = TX, 3 = RX, 5 = GND

Contact closure ............................ 1 9-pin female D connector (also used for RS-232)

Contact closure pin configuration. 1 = input #1, 4 = input #2, 5 = GND

Program control ........................... Extron’s control program for Windows

Extron’s Simple Instruction Set

™ – SIS™

General

Input power .................................. 100VAC to 240VAC, 50/60 Hz, 18 watts, internal, autoswitchable

MBC power jacks ......................... 9.0VDC, 0.15A

Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, non-condensing

Operating +32° to +113°F (0° to +45°C) / 10% to 90%, non-condensing

Rack mount ................................... Yes, with an optional rack shelf (part #60-190-01)

Furniture mount .......................... Yes, with an optional under-desk mounting kit (part #70-077-01) or

through-desk mounting kit (part #70-077-02)

Enclosure type .............................. Metal, vented

Enclosure dimensions ................. 1.75" H x 8.75" W x 8.6" D (1U high, half rack width)

4.4 cm H x 22.2 cm W x 21.8 cm D

(Depth excludes knobs.)

Product weight ............................. RGB 202 Rxi .............. 2.2 lbs (1.0 kg)

RGB 202 Rxi VTG .... 2.3 lbs (1.0 kg)

Shipping weight ........................... 5 lbs (2.3 kg)

Vibration ....................................... ISTA/NSTA 1A in carton (International Safe Transit Association)

Listings .......................................... UL, CUL

Compliances ................................. CE, FCC Class A

MTBF ............................................. 30,000 hours

Warranty ....................................... 3 years parts and labor

Specifications are subject to change without notice.

(7.40-121602-D4)

1-3RGB 202 Rxi , RGB 202 Rxi VTG • Specifications