Extron electronic PVT SW HDMI D User Manual
IMPORTANT:
HDMI IN
AUDIO IN
IR OUT
S
G
HDMI IN
AUDIO IN
Decora
®
Faceplate
Wall
Mud Ring
Extron
PVT SW HDMI D
STP Cable
from PoleVault Switcher
Inser
Pins:
PVT SW HDMI D • Installation Guide
Go to www.extron.com for the
complete system installation guide,
instructions, and specifications.
The Extron® PVT SW HDMI D is a
2-gang AV wallplate for PoleVault®, PlenumVault™ and WallVault™
AUDIO IN
HDMI IN
AUDIO IN
HDMI IN
Systems that support the PVS 405D switcher. It passes HDMI/DVI
video with analog stereo audio signals to the PoleVault digital
switcher up to 150 feet away over shielded twisted pair (STP) cable.
The PVT has two HDMI connectors, two audio input jacks, and one
IR OUT
S
G
IR connector (on the left front panel).
Installation
NOTES:
• Install the wallplate directly into the wall using the supplied mud ring or a UL Listed
2-gang junction box (not supplied) such as a RACO 232, following the steps below.
• If installing a junction box, allow enough depth for the wallplate and cables. Take into
consideration the bend radius of the cable. Do not bend the cables at 90 degrees.
• Conduit and conduit adapters should be used.
1. Using the mud ring or a junction box as a guide, mark the edges and cut out the material
within the marked area of the mounting location.
2. Either:
• Insert the mud ring into the opening,
rotate the locking arms, and secure with
the supplied screws,
or
• Insert the wall box and secure with
nails or screws.
3. Run the STP cable from the PoleVault
switcher location, going behind the wall and
to the PVT location, then thread the cables
through the mud ring or wall box.
NOTES:
• Extron highly recommends shielded
twisted pair (STP) cabling with shielded
RJ-45 plugs.
• The STP cables supplied are terminated
to TIA 568A standard.
4. Plug the STP cable from the PoleVault switcher
into the RJ-45 connector labeled PVT Out on the
rear of the wallplate.
12345678
t Twisted
Pair Wires
RJ-45
Connector
Pin
1
2
3
4
5
6
7
8
Green
Blue
Orange
Brown
568A
Wire Color
White-green
White-orange
White-blue
White-brown
568B
Wire Color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
PVT SW HDMI D • Installation Guide (Continued)
5. Mount the cabled device into the mud ring or wall box and attach the supplied Decora®
faceplate.
6. Connect HDMI sources to the two front panel HDMI input connector.
7. Connect audio sources to the audio input jacks.
8. Connect the IR emitter to the front panel 2-pole captive screw connector with the signal
wire in the hole marked “S” and the ground wire in the hole marked “G.”
Place the IR emitter near or in front of the IR pickup sensor on the source device.
NOTE: To complete system installation, see the Digital PoleVault System Installation Guide
(featuring the PVS 405D switcher), available online at www.extron.com.
Extron USA Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX +1.919.850.1001 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
© 2013 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Europe
+800.3987.6673 (Inside Europe Only)
+31.33.453.4040
+31.33.453.4050 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777 (Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
68-2382-01
Rev A
10 13
Loading...