Extron EDID 101H Installation Manual

IMPORTANT:

IMPORTANT:

A

(5 mm) Max.

X

EDID 101H 4K PLUS • Setup Guide

This setup guide provides instructions for an experienced installer to install and operate the EDID 101H 4K PLUS.

The EDID 101H 4K PLUS is a single-input, single-output HDMI EDID emulator supporting video rates up to 4K@60 Hz 4:4:4. It
supports EDID Minder, HDCP 2.3, and Extron Product Conguration Software (PCS) conguration. The EDID 101H 4K PLUS can
also capture and store EDID information from a connected display via the front panel STORE button.

The EDID 101H 4K PLUS is housed in a 1 inch high, quarter-rack width, 6-inch deep enclosure. An external universal power
supply is included.

NOTE: For full installation, conguration, menus, connector wiring, and operation details, see the EDID 101H 4K PLUS User

Guide, available at www.extron.com

Go to www.extron.com for the

complete user guide, installation

instructions, and specifications.

Rear Panel Cabling

A

POWER
12V

0.3A MAX

B

C

EDID 101H 4K PLUS

OUTPUTINPUT

Figure 1. EDID 101H 4K Plus Rear Panel

Power Connector — Connect the included 12VDC power supply to the orange, two-pole, 3.5mm captive screw

A

connector. Wire the power supply as shown in figure 2.

SECTION A–A

Smooth

Ridges

3/16"

A

POWER

12V

0.3A MA

Figure 2. External Power Supply Connection

ATTENTION: Risk of property damage:

ATTENTION : Risque de dommages matériels :

• Do not connect any external power supplies until you have read the Attention notifications in the Power Supply section

of the user guide for that device.

• Ne branchez pas de sources d’alimentation externes avant d’avoir lu les mises en garde dans la section « Power Supply

» du guide utilisateur pour cet appareil.

HDMI Input — Connect an HDMI source to this HDMI connector.

B

HDMI Output — Connect a display or other output device to the HDMI connector.

c

1

EDID 101H 4K PLUS • Setup Guide (Continued)

3

HDMI Connector LockIt Lacing Bracket

3

4

3

5

2

1

Figure 3. Connecting HDMI Cable to LockIt Lacing Bracket

Use the Extron LockIt Lacing Bracket to secure HDMI cables to the device.

1. Plug the HDMI cable into the rear panel connection (see figure3,

2. Loosen the HDMI connection mounting screw from the panel enough to allow the LockIt Lacing Bracket to be

placed over it (2). The screw does not have to be removed.

3. Place the LockIt Lacing Bracket on the screw and against the HDMI connector (

secure the bracket.

ATTENTION:

• Do not overtighten the HDMI connector mounting screw. The shield to which it is fastened is very thin and can

easily be stripped.

• Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel elle est attachée est très fin et peut

facilement être dénudé.

4. Loosely place the included tie wrap around the HDMI connector and the LockIt Lacing Bracket as shown (

5. Hold the connector securely against the lacing bracket, tighten the tie wrap, then remove the excess length (

1

).

), then tighten the screw to

3

4

5

).

).

Front Panel

AB C

SIGNAL

CONFIG

HDCP

Figure 4. EDID 101H 4K Plus Front Panel

Power LED – Illuminates when power is supplied.

A

Config Port – Connect a USB mini-B cable to provide USB communication with unit.

B

EDID STORE Button – When pushed in, the STORE button initiates both reading and storing the EDID from the connected

C

display. Press the STORE button to read the EDID of the connected device and store it to a user slot selected by the rotary
switch. Up to four EDID files (switch positions C through F) can be stored.

Reset – To reset the EDID101H4K PLUS to its default state, press and hold the STORE button while applying power. As
power is applied, all front panel LEDs blink 3 times indicating a successful reset.

EDID Selection Rotary Switch – The 16-position rotary switch allows the user to select from 12 factory EDID files

D

and 4 store slots. When any position 0-F is selected, the corresponding slot in the EDID lookup table will be
assigned to the input, and an unsolicited SIS response will be sent. This is summarized in the table on the next
page.

IN OUT

STORE

EDID

D

4

5

3

6

7

2

8

1

9

0

A

F

B

E

C

D

EDID 101H 4K PLUSExtron

2