Extreme Networks RBTBF Revised manual

ENJOY THE FREEDOM OF WIRELESS NETWORKING

802.11a PC Card Installation and Specifications

™

ENTERASYS.COM

9033774 DRAFT

NOTICE

Enterasys Networks reserves the right to make changes in specifications and other information contained in
this document and its web site without prior notice. The reader should in all cases consult E nterasys Networks
to determine whether any such changes have been made.

The hardware, firmware, or software described in this document is subject to change without notice.
IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT,

SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO
LOST PROFITS) ARISING OUT OF OR RELAT ED TO THIS DOCUMENT, WEB SITE, OR THE
INFORMATION CONT AINED IN THEM, EVEN IF ENTERASYS NETWORKS HAS BEEN ADVISED
OF, KNEW OF, OR SHOULD HAVE KNOWN OF, THE POSSIBILITY OF SUCH DAMAGES.

Enterasys Networks, Inc.
35 Industrial W a y
Rochester, NH 03867

© 2003 Enterasys Networks, Inc. All rights reserved.

Part Number: 903xxxx DRAFT FEB 28-03

Enterasys Networks and ROAMABOUT are registered trademarks and ENTERASYS ROAMABOUT, and
any logos associated therewith, are trademarks of Enterasys Networks, Inc. in the United States and other
countries.

Microsoft, Windows, and Windows NT are trademarks or registered trademarks of Microsoft Corporation in
the United States and other countries.

PC Card is a trademark of PCMCIA in the United States and other countries.
All other product names mentioned in this manual may be trademarks or registered trademarks of their

respective companies.

Regulatory Information

CAUTION: Changes or modifications made to this device which are not expressly
approved by the party responsible for compliance could void the user’s authority to operate
the equipment.

Exposure to Radio Frequency Radiation.

The radiated output power of the IEEE 802.11 RoamAbout PC Card is far below the FCC radio frequency
exposure limits. Nevertheless, the RoamAbout PC Card shall be used in such a manner that the potential for
human contact during normal operation is minimized. When using this device in combination with RoamAbout
Outdoor Antenna products, a certain separation distance between antenna and nearby persons has to be kept to
ensure RF exposur e compliance. Refer to the Regul atory Statem ents as identifi ed in the docume ntation that co mes
with those products for additional information.

Interference Statement.

Canada - Industry Canada (IC).

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Ru le s. These limi ts are des ign ed t o p rovi de r eas ona ble protec ti on agai nst harm ful int erf erence i n a
residential installation.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.

This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance
with the instr uc tions, it ma y cau se h ar mful i nterf eren c e to radi o co mmunicat i ons. Howev er, ther e i s no guar ante e
that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and the receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio or TV technician for help.
Enterasys Networks is not responsible for any radio or television interference caused by unauthorized

modification of the devices included in this kit, or the substitution or attachment of connecting cables and
equipment other then specified by Enterasys Networks. The correction of interference caused by such
unauthorized modification, substitution or attachment will be the responsibility of the user.

For country-specific approvals, please consult the Radio Certification and Regulatory Information document
included in this kit. Visit the RoamAbout Wireless web site for updated country approvals.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.

cet appareil de la class B respecte toutes les exigences du Reglement sur le matereil brouiller du Canada.